Nissan Rogue (T33) 2021-Present Service Manual: P0112 Iat Sensor
DTC Description
DTC DETECTION LOGIC
| DTC |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| P0112 | 00 |
IAT SEN/CIRCUIT-B1 (Intake air temperature sensor 1 circuit low bank 1) |
Diagnosis condition | — |
| Signal (terminal) | Intake air temperature sensor signal | |||
| Threshold | An excessively low voltage from the sensor is sent to ECM | |||
| Diagnosis delay time | — | |||
POSSIBLE CAUSE
-
Intake air temperature sensor
FAIL-SAFE
Engine Control System
Not applicable
Stop/Start System
When a DTC is detected, the stop/start indicator lamp blinks slowly and the stop/start system operation is prohibited.
When ECM detects error while operating the stop/start system, ECM restarts the engine.
DTC CONFIRMATION PROCEDURE
PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
-
Turn ignition switch OFF and wait at least 10 seconds.
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 10 seconds.
>>
GO TO 2.
PERFORM DTC CONFIRMATION PROCEDURE
-
Turn ignition switch ON and wait at least 5 seconds.
-
Check 1st trip DTC.
Is 1st trip DTC detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
DTC Diagnosis Procedure
CHECK INTAKE AIR TEMPERATURE (IAT) SENSOR
Check intake air temperature sensor. Refer to Component Inspection.
Is the inspection result normal?
YES>>Check intermittent incident. Refer to Intermittent Incident.
NO>>Replace mass air flow sensor (with intake air temperature sensor). Refer to Removal and Installation.
Other materials:
Dtc/circuit Diagnosis. Rear Window Defogger Switch
Component Function Check
CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION
Check that the indicator lamp of rear window defogger illuminates when rear window defogger switch ON.
Is the inspection result normal?
YES>>
Rear window defogger switch function is OK.
NO>>
Refer to Diagnosis P ...
Basic Inspection. Calibration of Automatic Back Door Position Information
Description
When the following work is performed, it is necessary to perform
initial setting of automatic back door position information to operate
automatic back door system. Refer to Work Procedure.
After removing and installing, or replacing automatic back door control unit
After rem ...
Removal and Installation. Rear Door
Exploded View
Rear door panel
Grommet
Rear door striker
TORX bolt
Rear door check link
Rear door hinge (lower)
Rear door hinge (upper)
Rear door weather-strip
Double-sided tape [t: 1.2 mm (0.047 in)]
Double-sided tape [t: 0.8 mm (0.031 in)]
&n ...
