Nissan Rogue (T33) 2021-Present Service Manual: P00de Charge Air Cooler Coolant Temperature Sensor

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / P00de Charge Air Cooler Coolant Temperature Sensor

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
P00DE 00

Charge air cooler coolant temp sensor

(Charge Air Cooler Coolant Temperature Sensor "A" Circuit) 		Diagnosis condition Engine is run for 5 minutes after leaving the Nissan Ariya vehicle for 8 hours
Signal (terminal) Charge air cooler coolant temperature sensor signal
Threshold ECM detects the temperature difference between charge air cooler coolant temperature sensor and engine coolant temperature sensor 1, intake air temperature sensor, or fuel tank temperature sensor exceeds specific value.
Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors (Charge air cooler coolant temperature sensor circuit is open or shorted.)

  • Charge air cooler coolant temperature sensor

FAIL-SAFE

Not applicable

DTC Confirmation Procedure

INSPECTION START

Is it necessary to erase permanent DTC?

YES>>

GO TO 3.

NO>>

GO TO 2.

PERFORM COMPONENT FUNCTION CHECK

Perform Component Function Check. Refer to Component Inspection.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Proceed to DTC Diagnosis Procedure.

PRECONDITIONING

If DTC CONFIRMATION PROCEDURE has been previously conducted, always perform the following procedure before conducting the next test.

  1. Turn ignition switch OFF and wait at least 10 seconds.

  2. Turn ignition switch ON.

  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

  • Before performing the following procedure, do not add fuel.

  • Before performing the following procedure, check that fuel level is between 1/4 and 4/4.

  • Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

>>

GO TO 4.

PERFORM DTC CONFIRMATION PROCEDURE

  1. Move the Nissan Ariya vehicle to a cool place.

    NOTE:

    Cool the vehicle in an environment of ambient air temperature between −10°C (14°F) and 35°C (95°F).

  2. Turn ignition switch OFF and leave the Nissan Ariya vehicle for 12 hours.

    CAUTION:

    Never turn ignition switch ON during this procedure.

    NOTE:

    The Nissan Ariya vehicle must be cooled with the hood open.

  3. Start engine and let it idle for 20 minutes or more.

    CAUTION:

    Never turn ignition switch OFF during idling.

  4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

DTC Diagnosis Procedure

CHECK CHARGE AIR COOLER COOLANT TEMPERATURE SENSOR POWER SUPPLY

  1. Turn ignition switch OFF.

  2. Disconnect charge air cooler coolant temperature sensor harness connector.

  3. Turn ignition switch ON.

  4. Check the voltage between charge air cooler coolant temperature sensor harness connector and ground.

    + −

    Voltage

    (Approx.)
    Charge air cooler coolant temperature sensor
    Connector Terminal
    E42 2 Ground 5 V

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 2.

CHECK CHARGE AIR COOLER COOLANT TEMPERATURE SENSOR POWER SUPPLY CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Check the continuity between charge air cooler coolant temperature sensor harness connector and ECM harness connector.

    Charge air cooler coolant temperature sensor ECM Continuity
    Connector Terminal Connector Terminal
    E42 2 F72 34 Existed

  4. Also check harness for short to ground.

Is the inspection result normal?

YES>>

Perform the trouble diagnosis for ECM power supply circuit.

NO>>

Repair or replace error-detected parts.

CHECK CHARGE AIR COOLER COOLANT TEMPERATURE SENSOR GROUND CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect ECM harness connector.

  3. Check the continuity between charge air cooler coolant temperature sensor harness connector and ECM harness connector.

    Charge air cooler coolant temperature sensor ECM Continuity
    Connector Terminal Connector Terminal
    E42 1 F71 111 Existed

  4. Also check harness for short to power.

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace error-detected parts.

CHECK CHARGE AIR COOLER COOLANT TEMPERATURE SENSOR

Check the charge air cooler coolant temperature sensor. Refer to Component Inspection.

Is the inspection result normal?

YES>>

INSPECTION END

NO>>

Replace charge air cooler coolant temperature sensor. Refer to Exploded View.

    P00d2 Ho2s2 Heater
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00D2 00 Heated O2 sensor heater B1 sensor 2 (HO2S heater contro...
    P00e0 Charge Air Cooler Coolant Temperature Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00E0 00 Sub-Radiator Coolant Temperature Sensor Circuit Low (Ch...

    Other materials:

    System Description. Diagnosis System (bcm)
    Common Item CONSULT Function - COMMON ITEM BCM Refer to CONSULT Function (BCM - COMMON ITEM). Door Lock CONSULT Function - DOOR LOCK BCM Refer to CONSULT Function (BCM - DOOR LOCK). Intelligent Key CONSULT Function - INTELLIGENT KEY BCM Refer to CONSULT Function (BCM - INTE ...

    Removal and Installation. Front Power Window Switch Lh
    Removal and Installation CAUTION: Never bend the fixing pawl of power window switch finisher. REMOVALRemove power window switch finisher. Refer to Removal and Installation. Remove front power window switch (passenger side) from power window switch finisher . : Pawl INSTALLATIONInsta ...

    P12a8 Cruise Control
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P12A8 00 Cruise control communication (Cruise control) Diagnosis condition Ignition switch ON Signal CAN communication signal Threshold Abnormal driv ...