Nissan Rogue manuals

Nissan Rogue Service Manual: Mixture ratio self-learning value clear

Nissan Rogue Service Manual / Engine / Engine Control System / Basic inspection / Mixture ratio self-learning value clear

Description

This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.

Work Procedure

1.START

With CONSULT

  1.  Start engine and warm it up to normal operating temperature.
  2.  Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
  3.  Clear mixture ratio self-learning value by touching “CLEAR”.

With GST

  1. Start engine and warm it up to normal operating temperature.
  2.  Turn ignition switch OFF.
  3.  Disconnect mass air flow sensor harness connector.
  4.  Restart engine and let it idle for at least 5 seconds.
  5.  Stop engine and reconnect mass air flow sensor harness connector.
  6.  Select Service $03 with GST. Make sure DTC P0102 is detected.
  7.  Select Service $04 with GST to erase the DTC P0102.

>> END

Idle air volume learning
Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following ...

Fuel pressure
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT  Turn ignition switch ON.  Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” ...

Other materials:

P0841 transmission fluid pressure SEN/SW A
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0841 FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch “A” Circuit Range/Performance) When all of the following conditions are sa ...

B0010, B0011 passenger airbag module
DTC Logic DTC DETECTION LOGIC CONSULT name DTC DTC detecting condition Repair order ASSIST AIRBAG MODULE CIRCUIT [OPEN] B0010 Front passenger air bag module circuit (AS1) is open. Refer to SRC-49, "Diagnosis Procedure". ASS ...

Preparation
Special Service Tool The actual shape of the tool may differ from those illustrated here. Tool number (TechMate No.) Tool name Description KV991J0080 (J-45741) ABS active wheel sensor tester Checking operation of ABS active wheel sensors Comm ...

© 2014-2025 Copyright www.nirogue.com