Nissan Rogue (T33) 2021-Present Service Manual: Lib 12v Branch Line Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Lan System / Can :: Dtc/circuit Diagnosis / Lib 12v Branch Line Circuit

Diagnosis Procedure

CHECK CONNECTOR

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).

    • 12V sub battery (lithium ion battery)

    • BCM

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Disconnect the connector of BCM.

  2. Check the continuity between the BCM harness connector terminals.

    BCM harness connector Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    B123 104 E60 106 Existed
    103 107 Existed

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Check the harness and repair the root cause (Nissan Ariya vehicle CAN communication 2 circuit side). Refer to Diagnosis Procedure.

CHECK HARNESS FOR OPEN CIRCUIT

  1. Connect the connector of BCM.

  2. Disconnect the connector of 12V sub battery (lithium ion battery).

  3. Check the resistance between the 12V sub battery (lithium ion battery) harness connector terminals.

    12V sub battery (lithium ion battery) harness connector Resistance (Ω)
    Connector No. Terminal No.
    B142 3 2 Approx. 54 – 66

Is the measurement value within the specification?

YES>>

GO TO 4.

NO>>

Repair the 12V sub battery (lithium ion battery) branch line.

CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the 12V sub battery (lithium ion battery). Refer toDiagnosis Procedure .

Is the inspection result normal?

YES (Present error)>>

Replace the 12V sub battery (lithium ion battery). Refer to Removal and Installation.

YES (Past error)>>

Error was detected in the 12V sub battery (lithium ion battery) branch line.

NG>>

Repair the power supply and the ground circuit.

    Adp Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...
    M&a Branch Line Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damag...

    Other materials:

    Réglages
    Informations de base Le mode de réglages permet à l’utilisateur de personnaliser les informations affichées sur l’écran d’informations du véhicule ainsi que plusieurs paramètres de fonctionnement du Nissan Rogue. Ces réglages offrent une adaptation fine du véhicule selon vos préfére ...

    Entretien général
    Informations de base Lors de l’utilisation normale de votre Nissan Rogue, les opérations d’entretien général doivent être réalisées régulièrement et avec rigueur, conformément aux instructions décrites dans cette section. Toute apparition de bruits anormaux, de vibrations inhabituelle ...

    P0420 Three Way Catalyst Function
    DTC Description The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2.A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage capacity decreases, ...