Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: U237c-87 Can Comm Err (seat)

Nissan Rogue (T33) 2021-Present Service Manual / Electrical & Power Control :: Body Control System / Dtc/circuit Diagnosis :: U237c-87 Can Comm Err (seat)

DTC Description

DESCRIPTION

CAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line with high data communication speed and excellent error detection ability. Modern Nissan Ariya vehicle is equipped with many electronic control unit, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-High line, CAN-Low line) allowing a high rate of information transmission with less wiring. Each control unit transmits/receives data but selectively reads required data only. CAN Communication Signal Chart. Refer to CAN Communication Signal Chart.

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
U237C-87

CAN comm err (seat)

[CAN communication error (seat)] 		Diagnosis condition Ignition switch is ON.
Signal (terminal) CAN communication signal
Threshold BCM cannot communicate CAN communication signal.
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

CAN communication system

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAG RESULT

CONSULT

  1. Ignition switch ON and wait for 2 seconds or more.

  2. Select “Self diagnosis result” mode of “BCM”.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAN COMMUNICATION SYSTEM

Check CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

Inspection End.

    Dtc/circuit Diagnosis. U2369-87 Can Comm Err (psd/mhb)
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...
    Dtc/circuit Diagnosis. U2a06-88 Comm Bus Off V-Fd
    DTC Description DESCRIPTIONCAN (Controller Area Network) is a serial communication line for real time applications. It is an on-Nissan Ariya vehicle multiplex communication line...

    Other materials:

    Avm (around View Monitor Control Unit)
    B2a00-52 Side Camera Lh DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition B2A00-52 Left camera Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold The calibration is not completed or the connected camera ...

    Intake Air Temperature Sensor 2
    Component Inspection CHECK INTAKE AIR TEMPERATURE SENSOR 2 Turn ignition switch OFF. Disconnect turbocharger boost sensor harness connector. Check resistance between turbocharger boost sensor terminals as follows. Turbocharger boost sensor Condition Resistance (kΩ) + − ...

    Automatic Brake Hold. Symptom Diagnosis. Does Not Operate
    Does Not Operate Diagnosis Procedure Automatic brake hold function does not operate when the operating conditions are satisfied.PERFORM SELF-DIAGNOSIS (CHASSIS CONTROL MODULE) With CONSULT Perform self-diagnosis for “CHASSIS CONTROL”. Is DTC detected? YES>> Check the DTC. With ...