Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: C1713-7b Low Tire Pressure Rr

Nissan Rogue (T33) 2021-Present Service Manual / Suspension :: Road Wheels & Tires / Dtc/circuit Diagnosis :: C1713-7b Low Tire Pressure Rr

DTC Description

NOTE:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
C1713-7B

Low tire pressure RR

(Low tire pressure rear right) 		Diagnosis condition Drive at a speed of 25 MPH (40 km/h) or more reaches 10 minutes in total.
Signal (terminal) Tire pressure sensor signal.
Threshold Rear right tire air pressure drops to Approx. 75% or less from the specified value.
Diagnosis delay time 10 minutes or more.

NOTE:

  • DTC may be detected depending on a tire pressure change caused by a seasonal air temperature change.

  • The low tire pressure warning lamp may be OFF due to an increase in tire internal temperature, resulted from driving.

POSSIBLE CAUSE

  • Rear right tire air pressure is low

  • Air leak because of rear right wheel change

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION

CONSULT

  1. Ignition switch ON.

    CAUTION:

    Never start the engine.

  2. Check the tire pressure for all wheels and adjust to the specified value. Refer to Tire Air Pressure.

  3. Select “Self diagnostic result” mode of “BCM”.

  4. Drive the Nissan Ariya vehicle at 25 MPH (40 km/h) or more reaches 10 minutes in total.

Is DTC “C1713-7B detected"?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

NOTE:

The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information.

  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Description.

Is tire pressure sensor ID registration completed?

YES>>

GO TO 2.

NO>>

Replace rear right tire pressure sensor. Refer to Removal & Installation.

CHECK TIRE PRESSURE

Check the tire pressure of all wheels. Refer to Tire Air Pressure.

Is the inspection result normal?

YES>>

Perform “Confirmation Procedure” (self-diagnosis) again. Refer to DTC Description.

NO>>

GO TO 3.

CHECK TIRE PRESSURE SIGNAL

CONSULT

  1. Adjust tire pressure for all wheels to the specified value. Refer to Tire Air Pressure.

    NOTE:

    If the checked value is close to the standard, reduce the tire pressure, and then with the ignition switch ON, adjust the tire pressure again so that it is within the standard.

  2. Select "Air pressure-rear right" in "Data monitor" mode of "BCM [AIR PRESSURE MONITOR]".

  3. Check that the rear right tire pressures match the standard value. Refer to Reference Value.

Is the inspection result normal?

YES>>

After erasing DTC record, Inspection End.

NO>>

Replace rear right tire pressure sensor. Refer to Removal & Installation .

    Dtc/circuit Diagnosis. C1712-7b Low Tire Pressure Fr
    DTC Description NOTE: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information....
    Dtc/circuit Diagnosis. C1714-7b Low Tire Pressure Rl
    DTC Description NOTE: The Signal Tech II Tool [– (NI-50190)] can be used to perform the following functions: Refer to the Signal Tech II User Guide for additional information....

    Other materials:

    Dtc/circuit Diagnosis. B1029-09 Front Seat Belt Pre-Tensioner Lh
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B1029-09 Front seat belt pre-tensioner LH (Front seat belt pre-tensioner left hand) Diagnosis condition When ignition switch is ON. Signal (terminal) Front ...

    P02cd Fuel Injector
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P02CD 00 CYL1 INJECTOR OFFSET LEARNING (Cylinder 1 Fuel Injector "A" Offset Learning At Max Limit) Diagnosis condition Engine running During injector ...

    Main Line Between Lib 12v and M&a Circuit
    Diagnosis Procedure CHECK CONNECTOR Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). Harness connector B41 Harness con ...