Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B1029-12 Front Seat Belt Pre-Tensioner Lh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B1029-12 |
Front seat belt pre-tensioner LH (Front seat belt pre-tensioner left hand) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Front seat belt pre-tensioner LH signal | ||
| Threshold | Front seat belt pre-tensioner LH circuit is shorted to power supply circuit | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction or short circuit to power supply of harness and connector
-
Internal malfunction of front seat belt pre-tensioner LH
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
REPLACE FRONT SEAT BELT PRE-TENSIONER LH
-
Replace front seat belt pre-tensioner LH. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
C107c-53 Not Configuration
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C107C
53
Not configuration
(Not configuration)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
Signa ...
Dtc/circuit Diagnosis. Thigh Support Motor
Component Function Check
CHECK FUNCTION
CONSULT
Ignition switch ON.
Select “Thigh support motor” in “Active test” mode of “DRIVER SEAT”.
Check thigh support motor LH operation.
Test item Operation
Thigh support motor
Up
Thigh support
Upward
Down ...
Dtc/circuit Diagnosis. B2428-46 Automatic Back Door Control Unit
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B2428-46
Automatic back door control unit
(Automatic back door control unit)
Diagnosis condition
All times
Signal (terminal)
—
Threshold
Automatic ...
