Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0030-55 Rear Side A/b Module Lh
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen items (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B0030-55 |
REAR SIDE A/B MODULE LH (Second Row Left Side Airbag Deployment Control) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | Rear side air bag module LH signal | ||
| Threshold | When a mismatch is detected between in the configuration data stored in the air bag diagnosis sensor unit and Nissan Ariya vehicle specification. | ||
| Diagnosis delay time | 2 seconds or more. | ||
POSSIBLE CAUSE
-
Connection malfunction of harness and connector
-
Mistake of configuration for air bag diagnosis sensor unit
-
Internal malfunction of air bag diagnosis sensor unit
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
CHECK SELF DIAGNOSIS RESULT
CONSULT
-
Ignition switch ON.
-
Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.
Is malfunctioning part detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End
Diagnosis Procedure
WARNING:
-
Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
-
Never use unspecified tester or other measuring device.
CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Replace harness connector.
CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES>>GO TO 3.
NO>>Replace wiring harness.
PERFORM CONFIGURATION
-
Perform configuration for air bag diagnosis sensor unit. Refer to Description.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 4.
NO>>Inspection End
REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
-
Replace air bag diagnosis sensor unit. Refer to Removal and Installation.
-
Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
YES>>GO TO 1.
NO>>Inspection End
Other materials:
U012e Can Communication
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U012E
00
Communication error (lost)
(Lost communication with camshaft position control module)
Diagnosis condition
Engine running at idle
Signal (terminal)
C ...
B2723-88 Corner Sensor [rr]
DTC Description
DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2723-88
CORNER SENSOR [RR]
(Corner sensor [RR])
Diagnosis condition
When ignition switch is ON
Signal (terminal)
—
Threshold
Communication error
D ...
C107c-53 Not Configuration
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C107C
53
Not configuration
(Not configuration)
Diagnosis condition
When ignition switch is ON.
When the power supply voltage is normal.
Signa ...
