Nissan Rogue (T33) 2021-Present Service Manual: Dtc/circuit Diagnosis :: B0001-13 Driver Airbag Module

Nissan Rogue (T33) 2021-Present Service Manual / Restraints :: Srs Air Bag Control System / Dtc/circuit Diagnosis :: B0001-13 Driver Airbag Module

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen items

(Trouble diagnosis content) 		DTC Detection Condition
B0001-13

DRIVER AIRBAG MODULE

(Driver Frontal Stage 1 Deployment Control) 		Diagnosis condition When ignition switch is ON.
Signal (terminal) Driver air bag module signal
Threshold

Driver air bag module circuit is open

(including the spiral cable)
Diagnosis delay time 2 seconds or more.

POSSIBLE CAUSE

  • Connection malfunction or open circuit of harness and connector

  • Internal malfunction of driver air bag module

  • Internal malfunction of air bag diagnosis sensor unit

FAIL-SAFE

—

DTC CONFIRMATION PROCEDURE

CHECK SELF-DIAGNOSIS RESULT

CONSULT

  1. Ignition switch ON.

  2. Perform “Self diagnosis result” mode of “AIR BAG” using CONSULT.

Is malfunctioning part detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: Inspection End

Diagnosis Procedure

WARNING:

  • Before servicing, ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)

  • Never use unspecified tester or other measuring device.

CHECK HARNESS CONNECTOR

Check the harness connector.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace harness connector.

CHECK WIRING HARNESS

Check the wiring harness externals.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace wiring harness.

CHECK SPIRAL CABLE CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect driver air bag module connector and spiral cable connector.

  3. Check continuity between spiral cable terminals.

    Terminal Continuity
    37 20 Existed
    38 19

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Replace spiral cable. Refer to Removal and Installation.

REPLACE DRIVER AIR BAG MODULE

  1. Replace driver air bag module. Refer to Removal and Installation.

  2. Perform DTC confirmation procedure. Refer to DTC Description.

Is DTC detected?

YES>>

GO TO 5.

NO>>

Inspection End

REPLACE AIR BAG DIAGNOSIS SENSOR UNIT

  1. Replace air bag diagnosis sensor unit. Refer to Removal and Installation.

  2. Perform DTC confirmation procedure. Refer to DTC Description.

Is DTC detected?

YES>>

GO TO 1.

NO>>

Inspection End

    Dtc/circuit Diagnosis. B0001-12 Driver Airbag Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0001-12 DRIVER AIRBAG MODULE (Driver Frontal Stage 1 Deploy...
    Dtc/circuit Diagnosis. B0001-1a Driver Airbag Module
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen items (Trouble diagnosis content) DTC Detection Condition B0001-1A DRIVER AIRBAG MODULE (Driver Frontal Stage 1 Deploy...

    Other materials:

    U2e52-87 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition U2E52 87 CAN communication error (ADAS control unit) Diagnosis condition When ignition switch is ON. Signal (terminal) CAN communication signal Threshold Not receiving from ADAS c ...

    C0513 Wheel Speed Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition C0513 00 Right rear wheel speed sensor (Right Rear Wheel Speed Sensor Range/Performance) Diagnosis condition Ignition switch ON Battery voltage: 11 V ...

    Symptom Diagnosis. Easy Fill Tire Alert Does Not Activate
    Description The easy fill tire alert does not function while inflating a tire when the CVT shift selector position is in P-range with the ignition switch ON or with the engine started.NOTE: After starting to inflate the tire, it takes a few seconds for the easy fill tire alert to function. ...