Nissan Rogue (T33) 2021-Present Service Manual: Basic Inspection :: Additional Service When Replacing Driver Seat Control Unit

Nissan Rogue (T33) 2021-Present Service Manual / Body Interior :: Automatic Drive Positioner / Basic Inspection :: Additional Service When Replacing Driver Seat Control Unit

Description

Each function is reset to the following condition when the driver seat control unit is replaced. For details, refer to Work Procedure.

Function Condition Procedure
Memory (Seat, mirror) Erased Perform memory storing
Log-in*1 Erased Perform log-in storing
Intelligent Key interlock*2 Erased Perform Intelligent Key interlock storing

*1: With navigation system

*2: Without navigation system

Work Procedure

REPLACE DRIVER SEAT CONTROL UNIT

Replace driver seat control unit. Refer to Removal and Installation.

Which is the Nissan Ariya vehicle specification?

With navigation system>>

GO TO 2.

Without navigation system>>

GO TO 4.

Nissan Ariya Vehicle SPECIFICATION RECOGNITION

  1. Connect battery negative terminal.

  2. Ignition switch ON and wait for 30 seconds or more.

    NOTE:

    When the driver seat control unit receives a signal from the AV control unit for 30 seconds after the battery is energized, it is recognized and set as the specifications of with navigation system.

>>

GO TO 3.

LOG-IN STORING

Perform log-in storing. Refer to System Description.

>>

GO TO 4.

MEMORY STORING

Perform memory storing. Refer to Description.

Which is the Nissan Ariya vehicle specification?

With navigation system>>

Work end.

Without navigation system>>

GO TO 5.

INTELLIGENT KEY INTERLOCK STORING

Perform Intelligent Key interlock storing. Refer to Description.

>>

Work End.

    Basic Inspection. Diagnosis and Repair Work Flow
    Work Flow OVERALL SEQUENCEDETAILED FLOWGET INFORMATION FOR SYMPTOM Get detailed information from the customer about the symptom (the condition and the environment when the incid...
    Basic Inspection. Memory Storing
    Description Always perform the memory storage when the driver seat control unit is replaced. The memory function will not operate normally if no memory storage is performed. For...

    Other materials:

    System Description. Diagnosis System (eps Control Unit)
    CONSULT Function APPLICATION ITEMSCONSULT can display each diagnostic item using the diagnostic test modes shown following: Diagnosis mode CGW Status Description Restricted Mode Diag Test Mode Open Mode Self Diagnostic Result Display Display Display Display non-network DTC whi ...

    Intelligent Key battery replacement
    WARNING Do not ingest the battery — Chemical Burn Hazard. This product contains a coin/button cell battery. If swallowed, it can cause severe internal burns within hours and may lead to death. Keep both new and used batteries away from children. If the battery compartment of your Nissan R ...

    C106c-01 Pressure Sensor
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition C106C 01 Pressure sensor (Pressure sensor) Diagnosis condition When ignition switch is ON. When the power supply voltage is normal. Signal (t ...