Nissan Rogue (T33) 2021-Present Service Manual: B2e35-11 Gps Antenna

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B2E35-11

GPS antenna

(Global positioning system antenna)
Diagnosis condition When ignition switch is ON
Signal (terminal) GPS antenna signal
Threshold Short to ground
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • GPS antenna signal circuit is short to ground

  • GPS antenna

FAIL-SAFE

Telematics can not send correct position

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “IVC” using CONSULT.

  5. Check DTC.

Is DTC B2E35-11 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK GPS ANTENNA SIGNAL CIRCUIT

  1. Turn ignition switch OFF.

  2. Disconnect TCU harness connector.

  3. Check the continuity between TCU harness connector (GPS antenna side) and ground.

    TCU Ground Continuity
    Connector Terminal
    M175 49 Not existed
    50

Is the check result normal?

YES>>

Replace TCU. Refer to Removal & Installation.

NO>>

Replace telematics antenna. Refer to Removal & Installation.

    B2e34-13 Tel Antenna
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E34-13 TEL antenna (Telephone antenna) Diagnosis condition...
    B2e35-12 Gps Antenna
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2E35-12 GPS antenna (Global positioning system antenna) Dia...

    Other materials:

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of customer's comments; Refer to Diagnostic Work ...

    Dtc/circuit Diagnosis. Horn Function
    Component Function Check CHECK FUNCTION CONSULT Ignition switch OFF. Perform “Horn” in “Active test” mode of “IPDM E/R”. Check the horn operation. Test item Description Horn On Horn Sounds (for 20 ms.) Is the operation normal? YES>> Ins ...

    U2a8c-88 Ethernet Circuit
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition U2A8C-88 Ethernet circuit Diagnosis condition When ignition switch is ON. Signal (terminal) — Threshold Lost ethernet communication with AV control unit Diagnosis delay time ...