Nissan Rogue (T33) 2021-Present Service Manual: B273b-11 Rear Sensor Power Supply
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B273B-11 |
REAR SENSOR POWER (Rear sensor power) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Rear sensor power supply | |||
| Threshold | Short to ground | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
Harness or connector (Rear sensor power supply circuit is short to ground)
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B273B-11” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK REAR SENSOR POWER SUPPLY CIRCUIT (SHORT)
-
Turn ignition switch OFF.
-
Disconnect sonar control unit connector, rear sonar sensor LH/RH outer connector, rear sonar sensor LH/RH inner connector and rear sonar sensor LH/RH side connector.
-
Check continuity between sonar control unit harness connector and ground.
| Sonar control unit | Ground | Continuity | |
| Connector | Terminal | ||
| B20 | 23 | Not existed | |
Is the inspection result normal?
YES>>Replace the sonar control unit. Refer to Removal and Installation.
NO>>Repair the harness or connector.
Other materials:
Parking brake
Basic information
WARNING
Never drive the vehicle with the parking brake applied. The brake will overheat and fail to operate and will lead to an accident.
Never release the parking brake from outside the vehicle. If the vehicle moves, it will be impossible to push the foot brake pedal and will l ...
U224a-87 Can Comm Err (awd/4wd)
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
U224A
87
CAN comm err (AWD/4WD)
[Controller area network communication error (AWD/4WD control unit)]
1
Diagnosis condition
When ignition switch is ON.
...
Dtc/circuit Diagnosis. B1029-09 Front Seat Belt Pre-Tensioner Lh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B1029-09
Front seat belt pre-tensioner LH
(Front seat belt pre-tensioner left hand)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Front ...
