Nissan Rogue (T33) 2021-Present Service Manual: B2731-68 Side Sensor [rr]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2731-68

SIDE SENSOR [RR]

(Side sensor [RR])
Diagnosis condition When ignition switch is ON
Signal (terminal)
Threshold Magnetic noise detected
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Magnetic noise detected

  • Rear sonar sensor RH side

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B2731–68” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK SONAR SENSOR

Check if there is any noise generating factor near sonar sensor.

Was there any factor?

YES>>

Remove a factor.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC B2731-68 detected again?

YES>>

Replace the rear sonar sensor RH side. Refer to Removal and Installation.

NO>>

INSPECTION END

    B2731-65 Side Sensor [rr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2731-65 SIDE SENSOR [RR] (Side sensor [RR]) Diagnosis condition...
    B2731-81 Side Sensor [rr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2731-81 SIDE SENSOR [RR] Side sensor [RR] Diagnosis condition W...

    Other materials:

    C1213-A3 Control Unit Power Supply
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detecting condition C1213-A3 BATTERY VOLTAGE (Battery voltage) Diagnosis condition Ignition switch: ON Signal Battery power supply signal (terminal #6) Threshold Battery po ...

    Repair Information. Preparation
    Repairing Material Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the Nissan Ariya vehicle. Use the following procedure(s) to replace any factory-installed foam insulators.URETHANE FOAM APPLICATIONSUse commercially availabl ...

    Symptom Diagnosis. Intelligent Key Low Battery Warning Does Not Operate
    Diagnosis Procedure CHECK INFORMATION DISPLAY Check information display. Refer to Work flow. Is the inspection result normal? YES>> GO TO 2. NO>> Repair or replace the malfunctioning parts. CHECK INTELLIGENT KEY BATTERY Check Intelligent Key battery. Refer to Component Inspe ...