Nissan Rogue (T33) 2021-Present Service Manual: B272a-12 Center Sensor [fl]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B272A-12 |
CENTER SENSOR [FL] (Center sensor [FL]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Front sonar sensor signal LH inner | |||
| Threshold | Short circuit to power supply | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
-
Harness and connector between sonar control unit and front sonar sensor LH inner
-
Front sonar sensor LH inner
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B272A–12” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
CHECK FRONT SONAR SENSOR SIGNAL LH INNER CIRCUIT (1)
-
Turn ignition switch OFF.
-
Disconnect sonar control unit connector and front sonar sensor LH inner connector.
-
Turn ignition switch ON.
-
Check voltage between sonar control unit harness connector and ground.
Sonar control unit (-) Voltage (Approx. ) Connector Terminal B20 2 Ground 0 V
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair harness or connector.
CHECK FRONT SONAR SENSOR SIGNAL LH INNER CIRCUIT (2)
-
Turn ignition switch OFF.
-
Check continuity between front sonar sensor LH inner harness connector and ground.
| Front sonar sensor LH inner | Ground | Continuity | |
| Connector | Terminal | ||
| E305 | 2 | Not existed | |
Is the inspection result normal?
YES>>Replace the front sonar sensor LH inner. Refer to Removal and Installation.
NO>>Repair the harness or connector.
Other materials:
Lane Branch Line Circuit
Diagnosis Procedure
CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the front camera unitfor damage, bend and loose connection (unit side and connector side).
Is the inspection result no ...
Dtc/circuit Diagnosis. U0075-00 Communication Bus C Off
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
U0075-00
Control module comm Bus C Off
(Control module communication Bus C Off)
Diagnosis condition
Ignition switch ON
Signal (terminal)
CAN communication s ...
Dtc/circuit Diagnosis. B0028-09 Side A/b Module Rh
DTC Description
DTC DETECTION LOGIC DTC No.
CONSULT screen items
(Trouble diagnosis content) DTC Detection Condition
B0028-09
SIDE A/B MODULE RH
(Right Side Airbag Deployment Control)
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
Front side air bag modu ...
