Nissan Rogue (T33) 2021-Present Service Manual: B2723-92 Corner Sensor [rr]
DTC Description
DTC DETECTION LOGIC
| DTC | CONSULT screen items (Trouble diagnosis content) | DTC detection condition | ||
|---|---|---|---|---|
| B2723-92 |
CORNER SENSOR [RR] (Corner sensor [RR]) |
Diagnosis condition | When ignition switch is ON | |
| Signal (terminal) | Rear sonar sensor signal RH outer | |||
| Threshold | An abnormal sensor signal is input from sonar sensor | |||
| Diagnosis delay time | 4 seconds or more | |||
POSSIBLE CAUSE
Rear sonar sensor RH outer
FAIL-SAFE
Stop the obstacle detection function
CONFIRMATION PROCEDURE
PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT
-
Turn ignition switch ON.
-
Turn ignition switch OFF and wait at least 30 seconds.
-
Turn ignition switch ON and wait at least 30 seconds or more.
-
Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.
-
Check the DTC.
Is DTC “B2723–92” detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: INSPECTION END
Diagnosis Procedure
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
With CONSULT
-
Turn ignition switch ON.
-
Erase DTC.
-
Perform DTC confirmation procedure again. Refer to DTC Description.
Is DTC B2723-92 detected again?
YES>>Replace the rear sonar sensor RH outer. Refer to Removal and Installation.
NO>>INSPECTION END
Other materials:
Power Socket. Removal and Installation. Power Socket
Power Socket
Console Power Socket
Removal and Installation
REMOVALRemove switch panel. Refer to Removal and Installation.
Press the power socket fixing pawls from the back of the switch panel to remove the power socket.
: Pawl
INSTALLATIONNote the following, and install in the reve ...
C1f80-55 Steering Wheel Touch Sensor
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F80
55
Steering wheel touch sensor
(Steering wheel touch sensor)
Diagnosis condition
When engine is running
Signal (terminal)
...
U2a8c-88 Ethernet Circuit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detected condition
U2A8C-88
Ethernet circuit
Diagnosis condition
When ignition switch is ON.
Signal (terminal)
—
Threshold
Lost ethernet communication with AV control unit
Diagnosis delay time ...
