Nissan Rogue (T33) 2021-Present Service Manual: B2720-65 Corner Sensor [rl]

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition
B2720-65

CORNER SENSOR [RL]

(Corner sensor [rear left])
Diagnosis condition When ignition switch is ON
Signal (terminal)
Threshold Sonar sensor temperature is high
Diagnosis delay time 4 seconds or more

POSSIBLE CAUSE

  • Sonar sensor temperature is high

  • Rear sonar sensor LH outer

FAIL-SAFE

Stop the obstacle detection function

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait at least 30 seconds.

  3. Turn ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check the DTC.

Is DTC “B2720–65” detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK SONAR SENSOR

Check whether there is any factor which causes a temperature rise near sonar sensor.

Was there any factor?

YES>>

Remove a factor.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

With CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC B2720-65 detected again?

YES>>

Replace the rear sonar sensor LH outer. Refer to Removal and Installation.

NO>>

INSPECTION END

    B2720-61 Corner Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2720-61 CORNER SENSOR [RL] (Corner sensor [rear left]) Diagnosi...
    B2720-68 Corner Sensor [rl]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2720-68 CORNER SENSOR [RL] (Corner sensor [rear left]) Diagnosi...

    Other materials:

    Steering Switch Signal B Circuit
    Component Function Check CHECK COMBINATION METER INPUT SIGNAL CONSULT Ignition switch ON. Select “Steering switch input” in “Data monitor” mode of “M&A”. Check that the function operates normally according to the following conditions: Condition Value CONTRO ...

    B2723-88 Corner Sensor [rr]
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen items (Trouble diagnosis content) DTC detection condition B2723-88 CORNER SENSOR [RR] (Corner sensor [RR]) Diagnosis condition When ignition switch is ON Signal (terminal) — Threshold Communication error D ...

    Periodic Maintenance
    Periodic Maintenance The following tables show the normal maintenance schedule. Depending upon weather and atmospheric conditions, varying road surfaces, individual driving habits and Nissan Ariya vehicle usage, additional or more frequent maintenance may be required.Periodic maintenance beyo ...