Nissan Rogue (T33) 2021-Present Service Manual: B24a1-17 A/c Auto Amp.
DTC Description
DTC DETECTION LOGIC
| DTC No. |
CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B24A1-17 |
A/C auto AMP. (Air conditioning automatic amplifier) |
Diagnosis condition | Ignition switch OFF |
| Signal (Terminal) | Accessory power supply | ||
| Threshold | Shorted to battery | ||
| Diagnosis delay time | 30 seconds or more | ||
POSSIBLE CAUSE
-
A/C amp.
-
Harness or connector (accessory power supply circuits is shorted to battery)
FAIL-SAFE
—
DTC CONFIRMATION PROCEDURE
PERFORM SELF DIAGNOSIS
CONSULT
-
Ignition switch ON.
-
Select "Self diagnosis result" mode of "HVAC".
-
Check DTC.
Is DTC detected?
YES>>Refer to Diagnosis Procedure.
NO-1>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO-2>>Confirmation after repair: Inspection End.
Diagnosis Procedure
CHECK A/C AMP. POWER SUPPLY AND GROUND CIRCUITS
Check A/C amp. power supply and ground circuits. Refer to Diagnosis Procedure.
Is the inspection result normal?
YES>>Replace A/C amp. Refer to Removal and Installation.
NO>>Repair or replace malfunctioning parts.
Other materials:
C1f41-84 Cvt
Without Propilot Assist 2.1
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content) DTC detection condition
C1F41
84
TRANSMISSION CIRCUIT
(Transmission circuit)
Diagnosis condition
When engine is running
When AEB system is O ...
Dtc/circuit Diagnosis. C18d6-09 Brake Power Supply Back up Unit
DTC Description
DTC DETECTION LOGIC DTC No. CONSULT screen terms DTC detection condition
C18D6
09
Backup power supply unit
1
Diagnosis condition
When Ignition switch is ON.
Signal (terminal)
Brake power supply backup unit signal
Threshold
When a malfunction is de ...
P00d2 Ho2s2 Heater
DTC Description
DTC DETECTION LOGIC DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P00D2
00
Heated O2 sensor heater B1 sensor 2
(HO2S heater control circuit range/performance bank 1 sensor 2)
Diagnosis condition
—
Signal (terminal)
...
