Nissan Rogue Service Manual: VIN registration
Description
VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.
NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M).
Work Procedure
1.CHECK VIN
Check the VIN of the vehicle and note it. Refer to GI-34, "Identification Number".
>> GO TO 2.
2.PERFORM VIN REGISTRATION
With CONSULT
- Turn ignition switch ON and engine stopped.
- Select “VIN REGISTRATION” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
- Follow the instruction of CONSULT display.
>> END
Additional service when replacing ECM
Description
When replacing ECM, the following procedure must be performed. (For details,
refer to EC-136, "Work Procedure".)
PROGRAMMING OPERATION
NOTE:
After replacing with a blank EC ...
Accelerator pedal released position learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor outp ...
Other materials:
Before starting the engine
Make sure the area around the vehicle is
clear.
Check fluid levels such as engine oil, coolant,
brake fluid, and windshield-washer fluid
as frequently as possible, or at least whenever
you refuel.
Check that all windows and lights are clean.
Visually inspect tires ...
Wheel sensor
FRONT WHEEL SENSOR
FRONT WHEEL SENSOR : Exploded View
Front LH wheel sensor
Harness connector
Slant line
FRONT WHEEL SENSOR : Removal and Installation
CAUTION:
Be careful not to damage front wheel sensor edge and sensor
rotor teeth.
When removing the front ...
Diagnosis system [ABS actuator and electric unit (control
unit)]
CONSULT Function
APPLICATION ITEMS
CONSULT can display each diagnostic item using the diagnostic test modes as
follows.
Mode
Function description
ECU identification
Parts number of ABS actuator and electric unit (control unit) can be
read.
Self Diagnos ...
