Nissan Rogue manuals

Nissan Rogue Owners Manual: Towing recommended by NISSAN

All-Wheel Drive (AWD) models
All-Wheel Drive (AWD) models

NISSAN recommends that towing dollies be used when towing your vehicle or the vehicle be placed on a flatbed truck as illustrated.

CAUTION

DO NOT tow AWD models with any of the wheels on the ground as this may cause serious and expensive damage to the powertrain.

Front-Wheel Drive models
Front-Wheel Drive models

NISSAN recommends that your vehicle be towed with the driving wheels (front) off the ground or place the vehicle on a flatbed truck as illustrated.

WARNING
  •  Never tow your vehicle with the front wheels on the ground or 4 wheels on the ground (forward or backward), as this may cause serious and expensive damage to the transmission. If it is necessary to tow the vehicle with the rear wheels raised always use towing dollies under the front wheels.
  •  When towing with the rear wheels on the ground or on towing dollies, place the ignition switch in the ON position, and secure the steering wheel in the straight-ahead position with a rope or similar device.
Towing your vehicle
When towing your vehicle, all jurisdictional and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NIS ...

Vehicle recovery (freeing a stuck vehicle)
Pulling a stuck vehicle WARNINGTo avoid vehicle damage, serious personal injury or death when recovering a stuck vehicle:  Contact a professional towing service to recov ...

Other materials:

P0452 EVAP control system pressure sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0452 EVAP SYS PRES SEN (Evaporative emission system pressure sensor/switch low) An excessively low voltage from the sensor is sent to ECM. ...

Power window relay
Description Power is supplied to the main power window and door lock/unlock with BCM control. Component Function Check 1. CHECK POWER WINDOW RELAY POWER SUPPLY CIRCUIT Check that an operation noise of power window relay [located behind the A/C switch assembly (automatic A/ C) or Front air c ...

Periodic maintenance
FRONT WHEEL HUB AND KNUCKLE Inspection Move the wheel hub and bearing in an axial direction by hand to verify that looseness of wheel hub and bearing exists. If any looseness exists, replace the wheel hub and bearing. Axial end play : Refer to FAX-32, "Wheel Bearing". Rota ...

В© 2014-2025 Copyright www.nirogue.com