Nissan Rogue manuals

Nissan Rogue Owners Manual: Towing your vehicle

When towing your vehicle, all jurisdictional and local regulations for towing must be followed.

Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NISSAN dealer. Local service operators are generally familiar with the applicable laws and procedures for towing. To assure proper towing and to prevent accidental damage to your vehicle, NISSAN recommends having a service operator tow your vehicle. It is advisable to have the service operator carefully read the following precautions:

WARNING
  •  Never ride in a vehicle that is being towed.
  •  Never get under your vehicle after it has been lifted by a tow truck.

 

CAUTION
  •  When towing, make sure that the transmission, axles, steering system and powertrain are in working condition. If any of these conditions apply, dollies or a flatbed tow truck must be used.
  •  Always attach safety chains before towing.

For additional information about towing your vehicle behind a recreational vehicle (RV), refer to “Flat towing” in the “Technical and Consumer Information” section of this manual.

If your vehicle overheats
WARNING  Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire.  To avoid the danger of being scalded, never rem ...

Towing recommended by NISSAN
All-Wheel Drive (AWD) models NISSAN recommends that towing dollies be used when towing your vehicle or the vehicle be placed on a flatbed truck as illustrated. CAUTIONDO NOT tow AWD mod ...

Other materials:

Combination meter
Reference Value VALUES ON THE DIAGNOSIS TOOL *: DDS (hill descent control) NOTE: Some items are not available according to vehicle specification. TERMINAL LAYOUT PHYSICAL VALUES Fail-safe The combination meter activates the fail-safe control if the CAN communica ...

Throttle valve closed position learning
Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time the harness connector of the electric throttle control actuator or ECM is ...

Luggage hooks
When securing items using luggage hooks located on the back of the seat or side finisher do not apply a load over more than 6.5 lbs (29 N) to a single hook. The luggage hooks that are located on the floor should have loads less than 110 lbs (490 N) to a single hook. The luggage hooks ...

© 2014-2021 Copyright www.nirogue.com