Nissan Rogue Service Manual: The oil pressure warning continues displaying, or does not display

Nissan Rogue Service Manual / Driver information & multimedia / Meter, Warning Lamp & Indicator / Symptom diagnosis / The oil pressure warning continues displaying, or does not display

Description

The low oil pressure warning message stays on when oil pressure is normal.
The low oil pressure warning message stays off when oil pressure is low.

Diagnosis Procedure

1.CHECK COMBINATION METER INPUT

Start the engine and select “METER/M&A” on CONSULT.
Observe “OIL W/L” in “Data Monitor” and the operation of the low oil pressure warning message in the information display.

Check combination meter input

Is the inspection result normal? YES >> Perform “Self Diagnosis” of “ECM”. Refer to EC-67, "CONSULT Function".

NO >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

The fuel gauge does not move

Description Fuel gauge does not move from a certain position. Diagnosis Procedure 1.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE Perform the self-diagnosis mode of combination meter, and t ...

The parking brake release warning continues displaying, or does not display

Description The parking brake warning is displayed during vehicle travel even though the parking brake is released. The parking brake warning is not displayed even though driving the ...

Other materials:

Windows
POWER WINDOWS WARNING Make sure that all passengers have their hands, etc. inside the vehicle while it is in motion and before closing the windows. Use the window lock switch to prevent unexpected use of the power windows. Do not leave children unatten ...

Interior room lamp control circuit
Description Controls each interior room lamp (ground side) by PWM signal. NOTE: PWM signal control period is approximately 250 Hz (in the gradual brightening/dimming). Component Function Check CAUTION: Before performing the diagnosis, check that the following is normal. Interior ro ...

P0127 IAT sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0127 IAT SENSOR-B1 (Intake air temperature too high) Rationally incorrect voltage from the sensor is sent to ECM, compared with the voltage ...