Nissan Rogue Service Manual: Preparation
Special Service Tools
The actual shapes of TechMate tools may differ from those of special service tools illustrated here.
| Tool number (TechMate No.) Tool name | Description | |
| 1. KV311039S0
( — )
Charging pipe set 2. KV31103920* ( — ) O-ring |
|
CVT fluid changing and adjustment |
| KV38107900 ( — ) Protector a: 32 mm (1.26 in) dia. |
|
Installing drive shaft |
*: The O-ring as a unit part is set as a SST.
Commercial Service Tools
| Tool number Tool name |
Description | |
| Power tool |
|
Loosening nuts and bolts |
| Lint-free paper |
|
Cleaning transaxle |
| Drift a: 56 mm (2.20 in) dia. b: 50 mm (1.97 in) dia. |
|
Installing differential side oil seal |
| Drift a: 65 mm (2.56 in) dia. b: 60 mm (2.36 in) dia. |
|
Installing converter housing oil seal |
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...
Other materials:
Unexpected brake pedal reaction
Description
A malfunction of brake pedal feel (height or others) is detected when brake
pedal is depressed.
Diagnosis Procedure
1.CHECK FRONT AND REAR AXLE
Check that there is no excessive looseness in front and rear axle.
2WD: Refer to FAX-7, "Inspection" (front) or RAX-6, ...
Removal and installation
NATS ANTENNA AMP.
Removal and Installation
REMOVAL
Remove the steering column covers. Refer to IP-17, "Removal and
Installation".
Disconnect the harness connector from the NATS antenna amp.
Release pawls and remove NATS antenna amp. (1) from the
ignition sw ...
Normal operating condition
Description
FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED)
If the engine speed is above 1,800 rpm under no load (for example, the
selector lever position is neutral and
engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact
time when the fuel is cut off varies
b ...
