Nissan Rogue manuals

Nissan Rogue Service Manual: Preparation

Special Service Tool

The actual shape of the tools may differ from those tools illustrated here.

Tool number (TechMate No.) Tool name

Description

— (J-50190) Signal Tech II

  • Activate and display TPMS transmitter IDs
  •  Display tire pressure reported by the TPMS transmitter
  •  Read TPMS DTCs
  •  Register TPMS transmitter IDs
  •  Check Intelligent Key relative signal strength
  •  Confirm vehicle Intelligent Key antenna signal strength
  •  Compatible with future sensors
  •  Equipped with a display
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

System description
COMPONENT PARTS BODY CONTROL SYSTEM BODY CONTROL SYSTEM : Component Parts Location BCM  Behind instrument panel (LH) POWER CONSUMPTION CONTROL SYSTEM POWER CONSUMPTION CONTROL SYS ...

Other materials:

P0300, P0301, P0302, P0303, P0304 misfire
DTC Description DTC DETECTION LOGIC When a misfire occurs, engine speed will fluctuate. If the engine speed fluctuates enough to cause the crankshaft position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is occurring. Sensor Input signal to ECM ECM functio ...

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow (With EXP-800 NI or GR8-1200 NI) CHARGING SYSTEM DIAGNOSIS WITH EXP-800 NI OR GR8-1200 NI To test the charging system, use the following special service tools:  EXP-800 NI Battery and electrical diagnostic analyzer  GR8-1200 NI Multitasking ...

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by p ...

© 2014-2021 Copyright www.nirogue.com