Nissan Rogue Service Manual: Personal lamp
Removal and Installation
The personal lamp is serviced as part of headlining. Refer to INT-30, "Removal and Installation".
Bulb or Lens Replacement
WARNING: Do not touch the glass surface of a bulb while it is lit or right after being turned OFF to prevent burns.
CAUTION:
- Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from bulb surface.
- Do not leave bulb out of lamp reflector for a long time because dust, moisture, smoke, etc. may affect the performance of lamp.
- Do not attempt to separate the personal lamp from the headlining or damage may occur.
- Insert a suitable tool into the gap between the lens and personal lamp, then gently release the lens pawls and remove.
- Grasp the bulb and pull straight out from its socket to remove.
- Install personal lamp bulb to personal lamp.
- Install the personal lamp lens.
Room lamp
Removal and Installation
WARNING:
Do not touch the glass surface of a bulb while it is lit or right after being
turned OFF to prevent burns.
CAUTION:
Do not touch the glass of bulb di ...
Luggage room lamp
Removal and Installation
REMOVAL
Insert a suitable tool (A) into the gap between the luggage lower
finisher (RH) (2) and the top of luggage room lamp (1) to release
the pawl.
: Pawl
...
Other materials:
Connecting Procedure
Connecting Procedure
NOTE:
The connecting procedure must be performed
when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.
Press the [ ] button
on the control
panel.
Touch the “Settings” key.
T ...
ECU diagnosis information
AV CONTROL UNIT
Reference Value
VALUES ON THE DIAGNOSIS TOOL
TERMINAL LAYOUT
PHYSICAL VALUES
DTC Index
BOSE SPEAKER AMP
Reference Value
TERMINAL LAYOUT
PHYSICAL VALUES
AROUND VIEW MONITOR CONTROL UNIT
WITHOUT DRIVER ASSISTANCE SYSTEM
WITHOUT DRIV ...
U0140 lost communication (BCM)
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
U0140
LOST COMM (BCM)
(Lost Communication With Body Control Module)
When the ignition switch is ON, TCM is unable to receive the CAN
communications ...
