Nissan Rogue manuals

Nissan Rogue Service Manual: Preparation

Special Service Tool

Tool number (TechMate No.) Tool name

Description
— (J-46534) Trim Tool Set

Removing trim components

Commercial Service Tool

(TechMate No.) Tool name

Description

( — ) Power tool

Loosening nuts, screws and bolts
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

System description
Component Part Location RH side of engine compartment  RH front of vehicle (view with front bumper fascia removed)  LH front of vehicle (view with front bumper fascia remove ...

Other materials:

P0340 CMP sensor (phase)
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting cond P0340 CMP SEN/CIRC-B1 (Camshaft position sensor ″A″ circuit bank 1 or single sensor) The cylinder No. signal is not sent to ECM ...

Periodic maintenance
REAR WHEEL HUB AND HOUSING Inspection INSPECTION Make sure the conditions (looseness, back lash) of each component and component conditions (wear, damage) are normal. WHEEL HUB AND BEARING INSPECTION  Move wheel hub and bearing in the axial direction by hand. Make sure there is no ...

B142A ignition voltage
Description DTC B142A IGNITION VOLTAGE Ignition voltage is supplied to the air bag diagnosis sensor unit when the ignition is in the ON position. The air bag diagnosis sensor unit will monitor for low or high ignition voltage. PART LOCATION Refer to SRC-6, "Component Parts Location" ...

© 2014-2025 Copyright www.nirogue.com