Nissan Rogue Service Manual: Parking brake shoe
Inspection and Adjustment
- Adjust parking brake pedal stroke. Refer to PB-4, "Inspection and Adjustment".
- Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
- Drive forward
- Vehicle speed: Approx. 40 km/h (25 MPH) set (constant and forward)
- Parking brake operating force: Approx. 160 +30.0 N (16.3 +3.1 kg-f, 36.0 +6.7 lb-f)
- Time: Approx. 10 +5.0 seconds.
CAUTION: To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
- After the break-in procedure, check parking pedal stroke of parking brake.
CAUTION: If it is out of the specification, adjust again. Refer to PB-4, "Inspection and Adjustment".
ADJUSTMENT AFTER INSTALLATION
- Adjust the parking brake pedal stroke. Refer to PB-4, "Inspection and Adjustment".
- Rotate the disc brake rotor with the parking brake pedal released
and check that there is no drag.
CAUTION: If any drag is found, verify the parking brake components are installed and adjusted correctly.
Parking brake system
Inspection and Adjustment
INSPECTION
Pedal Stroke
Operate the parking brake pedal with a force of 196 N (20.0 kg-f,
44.1 lb-f). Check that the pedal stroke is
within the specified num ...
Other materials:
P0506 ISC system
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...
Panoramic roof glass
Exploded View
Panoramic roof glass
Glass lid
Side trim covers (LH/RH)
Front drain hose (LH/RH)
Moonroof motor assembly
Sunshade motor assembly
Moonroof front bracket (LH/RH)
Moonroof rear bracket (LH/RH)
Rear drain hose (LH/RH)
Moonroof unit assembly
Re ...
Combination meter
Removal and Installation
REMOVAL
Disconnect the negative battery terminal. Refer to PG-77, "Removal
and Installation".
Remove the cluster lid A. Refer to IP-20, "Removal and
Installation".
Remove screws (A), from the combination meter (1).
...
