Nissan Rogue Owners Manual: Parking brake

Nissan Rogue Owners Manual / Starting and driving / Parking brake

WARNING

Be sure the parking brake is fully released before driving. Failure to do so can cause brake failure and lead to an accident.
Do not release the parking brake from outside the vehicle.
Do not use the shift lever in place of the parking brake. When parking, be sure the parking brake is fully engaged.
Do not leave children unattended in a vehicle. They could release the parking brake and cause an accident.

Parking brake

To engage: Firmly depress the parking brake.

To release:

Firmly apply the foot brake.
Move the shift lever to the P (Park) position.
Firmly depress the parking brake pedal and it will release.
Before driving, be sure the brake warning light goes out.

Driving the vehicle

CONTINUOUSLY VARIABLE TRANSMISSION (CVT) The Continuously Variable Transmission (CVT) in your vehicle is electronically controlled to produce maximum power and smooth operation. The recommended ...

ECO mode switch (if so equipped)

ECO mode switch The ECO mode helps to enhance the fuel economy by controlling the throttle sensitivity and transmission points. To turn on the ECO mode, push the ECO mode switch. The ECO mo ...

Other materials:

P0125 ECT sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0125 ECT SENSOR (Insufficient coolant temperature for closed loop fuel control) Voltage sent to ECM from the sensor is not practical, ...

System
System Description When the vehicle has reached a speed of 40 km/h (25 MPH) or greater, the BCM receives a signal transmitted from the tire pressure sensors installed in each wheel. If the BCM detects low inflation pressure or a system malfunction, it sends a signal to the combination meter v ...

Removal and installation
NATS ANTENNA AMP. Removal and Installation REMOVAL Remove the steering column covers. Refer to IP-17, "Removal and Installation". Disconnect the harness connector from the NATS antenna amp. Release pawls and remove NATS antenna amp. (1) from the ignition sw ...