Nissan Rogue manuals

Nissan Rogue Owners Manual: NISSAN Voice Recognition System (if so equipped)

The NISSAN Voice Recognition system allows hands-free operation of the systems equipped on this vehicle, such as the phone and navigation systems.

To operate NISSAN Voice Recognition, press the button located on the steering wheel.

When prompted, speak the command for the system you wish to activate. The command given is picked up by the microphone and performed when it is properly recognized. NISSAN Voice Recognition will provide a voice response as well as a message in the center display to inform you of the command results.

Bluetooth® settings
Bluetooth® settings To access the phone settings:  Press the [ ] button.  Touch the “Settings” key.  Touch the “Phone & Bluetooth” key. Menu Item ...

Using the system
Initialization When the ignition switch is in the ON position, NISSAN Voice Recognition is initialized, which takes a few seconds. When completed, the system is ready to accept voice commands. If ...

Other materials:

Car phone or CB radio
When installing a CB, ham radio or car phone in your vehicle, be sure to observe the following precautions; otherwise, the new equipment may adversely affect the engine control system and other electronic parts. WARNING  A cellular phone should not be used for any purpose wh ...

Additional service when replacing ECM
Description When replacing ECM, the following procedure must be performed. (For details, refer to EC-136, "Work Procedure".) PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sure to follow the procedure to perform t ...

C1144 incomplete steering angle sensor adjustment
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1144 ST ANG SEN SIGNAL When neutral position adjustment of steering angle sensor is not complete. Harness or connector  Steering angle sensor &n ...

© 2014-2025 Copyright www.nirogue.com