Nissan Rogue Service Manual: VDC off indicator lamp
Component Function Check
1.CHECK VDC OFF INDICATOR LAMP FUNCTION (1)
Check that VDC OFF indicator lamp in combination meter turns ON for 1 second after ignition switch is turned ON.
CAUTION: Never start the engine. Is the inspection result normal? YES >> GO TO 2.
NO >> Proceed to BRC-123, "Diagnosis Procedure".
2.CHECK VDC OFF INDICATOR LAMP FUNCTION (2)
Check that VDC OFF indicator lamp in combination meter turns ON/OFF when VDC OFF switch is operated.
Is the inspection result normal? YES >> Inspection End.
NO >> Check the VDC OFF switch system. Refer to BRC-117, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit.
Refer to BRC-123, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.CHECK VDC OFF INDICATOR LAMP SIGNAL
With CONSULT
- Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.
- Turn the ignition switch OFF.
- Check that data monitor displays “On” for 1 second after ignition switch is turned ON, and then changes to “Off”.
CAUTION: Never start the engine. Is the inspection result normal? YES >> GO TO 3.
NO >> Replace the ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
3.CHECK VDC OFF INDICATOR LAMP SIGNAL
With CONSULT
- Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.
- Check that data monitor displays “On” or “Off” each time when VDC OFF switch is operated.
Is the inspection result normal? YES >> Replace the combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Check the VDC OFF switch system. Refer to BRC-117, "Diagnosis Procedure".
VDC warning lamp
Component Function Check
1.CHECK VDC WARNING LAMP FUNCTION
Check that VDC warning lamp in combination meter turns ON for 1 second after
ignition switch is turned ON.
CAUTION:
Never start the e ...
Other materials:
Oil filter
Removal and Installation
REMOVAL
Remove fender protector side cover (RH). Refer to EXT-28, "FENDER
PROTECTOR : Exploded View".
Drain engine oil. Refer to LU-8, "Draining".
Remove oil filter using suitable tool (A)..
: Front
WARNING:
Be careful ...
B142X collision detection
Description
DTC B1209 - B1211 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a deployment
of one or more air bags or pre-tensioners. If this DTC is detected after a SRS
repair, the air bag diagnosis
sensor unit has ...
P0453 EVAP control system pressure sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0453
EVAP SYS PRES SEN
(Evaporative emission system pressure
sensor/switch high)
An excessively high voltage from the sensor is sent to ECM.
...
