Nissan Rogue (T33) 2021-Present Service Manual: U2176 Can Comm Circuit

Nissan Rogue (T33) 2021-Present Service Manual / Engine :: Engine Control System / Kr15ddt :: Dtc/circuit Diagnosis / U2176 Can Comm Circuit

DTC Description

DTC DETECTION LOGIC

DTC

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
U2176 57

CAN comm err (Intelligent Key)

[CAN comm err (Intelligent Key)] 		Diagnosis condition —
Signal (terminal) —
Threshold MAC communication error
Diagnosis delay time —

POSSIBLE CAUSE

  • MAC communication error

  • ECM used in other vehicles is installed in the Nissan Ariya vehicle

  • ECM

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

CHECK DTC PRIORITY

If DTC U2176 is displayed with DTC U1327, first perform the trouble diagnosis for DTC U1327.

Is DTC U1327 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

CHECK MAC DIAGNOSIS

With CONSULT

  1. Ignition switch ON.

  2. Perform “MAC Diagnosis” mode of “ENGINE” using CONSULT.

Is DTC U2176 detected?

YES>>

Refer to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK DTC PRIORITY

If DTC U2176 is displayed with DTC U1327, first perform the trouble diagnosis for DTC U1327.

Is DTC U1327 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

CHECK MAC DIAGNOSIS

With CONSULT

Perform “MAC Diagnosis” mode of “ENGINE” using CONSULT.

Is DTC U2176 detected with DTC U214F at the same time?

YES>>

all DTC codes are detected at the same time: Replace ECM. Refer to ECM : Removal & Installation.

NO>>

all DTC codes are not detected at the same time: GO TO 3.

CHECK CAN COMMUNICATION SYSTEM

Perform trouble diagnosis of CAN communication system. Refer to Trouble Diagnosis Flow Chart.

>>

INSPECTION END

    U2175 Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U2175 57 CAN comm err (AVM) [CAN comm err (AVM)] Diagnosis condi...
    U218b Can Comm Circuit
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms DTC detection condition U218B 83 CAN communication error Diagnosis condition Ignition switch ON Signal (terminal) CA...

    Other materials:

    Automatic Air Conditioning. Preparation. Preparation
    Preparation Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name   Description  — (NI-46534) Trim Tool Set Removing trim components Commercial Service Tools Tool name Description Power ...

    B3a70 Intelligent Battery Sensor
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition B3A70 00 IBS Battery Temp Sensor Failure (Open Circuit) [IBS battery temp sensor failure (Open circuit)] Diagnosis condition Ignition switch ON Batte ...

    Dtc/circuit Diagnosis. Passenger Door Mirror Control Module
    Diagnosis Procedure CHECK FUSE Ignition switch OFF. Check that the following fuse is not blown (open): Unit Location Fuse No. Capacity Passenger door mirror control module Fuse block (J/B) 45 5 A   Is the fuse blown (open) ? YES>> Replace the bl ...