Nissan Rogue Service Manual: P155D generator

Nissan Rogue Service Manual / Engine / Engine Control System / DTC/Circuit diagnosis / P155D generator

DTC Description

DTC DETECTION LOGIC

DTC No.	CONSULT screen terms (Trouble diagnosis content)	DTC detecting condition
P155D	GENERATOR (Generator)	ECM receives mechanical malfunction signal sent from generator. ECM receives electrical malfunction signal sent from generator.

POSSIBLE CAUSE

Generator

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted. always perform the following procedure before conducting the next test.

Turn ignition switch OFF and wait at least 10 seconds.
Turn ignition switch ON.
Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 2.

2.PERFORM DTC CONFIRMATION PROCEDURE

Start the engine and let it idle at least 10 seconds.
Check DTC.

Is DTC detected? YES >> Proceed to EC-175, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK CHARGING SYSTEM

Perform trouble diagnosis for charging system. Refer to EC-165, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace error-detected parts.

2.CHECK INTERMITTENT INCIDENT

Check intermittent incident. Refer to GI-41, "Intermittent Incident".

Is the inspection result normal? YES >> Replace generator. Refer to CHG-20, "Removal and Installation".

NO >> Repair or replace error-detected parts.

P1226 TP sensor

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P1226 CTP LEARNING-B1 (CTP LEARNING-B1) Closed ...

1564 ASCD steering switch

DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P1564 ASCD SW (ASCD switch) An excessi ...

Other materials:

Fusible link inspection
How To Check A melted fusible link can be detected either by visual inspection or by feeling with finger tip. If its condition is questionable, use circuit tester or test lamp. Fusible link With stop/start system Without stop/start system* *: Not applicable CAUTION: If ...

Wiring diagram
POWER DOOR LOCK SYSTEM Wiring Diagram INTELLIGENT KEY SYSTEM Wiring Diagram AUTOMATIC BACK DOOR SYSTEM Wiring Diagram HOMELINK UNIVERSAL TRANSCEIVER Wiring D ...

P0743 torque converter
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0743 TORQUE CONVERTER (Torque Converter Clutch Circuit Electrical) When all of the following conditions are satisfied and this state is maintained ...