Basic information
The current status of the Idling Stop System can be viewed in the vehicle information display.
Idling Stop System indicator
This indicator illuminates when the Idling Stop System is active.
The indicator blinks if the system is malfunctioning.
NOTE:
If the indicator blinks, have the system inspected and repaired as necessary. It is recommended to visit a NISSAN dealer for this service.
Idling Stop System ON or OFF
When the Idling Stop System is activated or deactivated using the Idling Stop OFF switch, a message will appear in the vehicle information display.
Fuel saved and engine stop time
The fuel saved/engine stop time mode displays:
The total fuel saved and total engine stop time can also be viewed in the vehicle information display.
Auto start deactivation
If the engine stops via the Idling Stop System and cannot restart automatically, a message will be displayed.
System fault
This message appears when the Idling Stop System is malfunctioning.
It is recommended that the system be checked by a NISSAN dealer.
Idling Stop inhibition
This indicator appears when the engine is prevented from automatically stopping due to Inhibition Conditions.
Idling Stop guidance display (further depressing the brake pedal)
This guidance appears when the Idling Stop System is deactivated because the brake pedal is not fully depressed.
Further depress the brake pedal if you wish to activate the Idling Stop System.
The display appears when the “fuel saved/engine stop time” screen is selected.
The display disappears when:
Idling Stop guidance display (detection of the steering operation)
This guidance appears when the Idling Stop System is deactivated because steering wheel movement is detected.
The system remains deactivated while steering input is detected.
The display disappears when:
Idling Stop guidance display (priority to air conditioner)
This guidance appears when the Idling Stop System is deactivated because cooling, heating, or dehumidifying functions are prioritized.
The display disappears when:
Idling Stop OFF switch
The Idling Stop System can be temporarily disabled by pressing the Idling Stop OFF switch. Press the switch again, or restart the engine, to reactivate the system.
NOTE:
Basic information
Cold weather drivingP0444, P0445 EVAP canister purge volume control solenoid
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0444
PURG VOLUME CONT/V
(Evaporative emission system purge control
valve circuit open)
An excessively low voltage signal is sent to ECM through ...
VIN registration
Description
VIN Registration is an operation to registering VIN in ECM. It must be
performed each time ECM is replaced.
NOTE:
Accurate VIN which is registered in ECM may be required for Inspection &
Maintenance (I/M).
Work Procedure
1.CHECK VIN
Check the VIN of the vehicle and note it. ...
Diagnosis system (BCM) (without intelligent key system)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
Direct Diagnostic Mode
Description
Ecu Identification
The BCM part number is displayed.
Self Diagnostic ...