Nissan Rogue manuals

Nissan Rogue Service Manual: C1604 torque sensor

DTC Logic

DTC DETECTION LOGIC

DTC

Display item

Malfunction detected condition

Possible cause

C1604 TORQUE SENSOR When torque sensor output signal is malfunctioning.
  • Harness or connector
  •  Torque sensor
  •  EPS control unit

DTC CONFIRMATION PROCEDURE

1.PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

>> GO TO 2.

2.DTC REPRODUCTION PROCEDURE

With CONSULT

  1.  Turn the ignition switch OFF to ON.
  2.  Perform “EPS” self-diagnosis.

Is DTC “C1604” detected? YES >> Proceed to diagnosis procedure. Refer to STC-23, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK TERMINALS AND HARNESS CONNECTORS

Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace malfunctioning parts.

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace malfunctioning parts.

2.PERFORM SELF-DIAGNOSIS

With CONSULT

  1.  Erase self-diagnostic results for “EPS”.
  2.  Turn the ignition switch OFF, and then wait 10 seconds and more.
  3.  Perform self-diagnosis for “EPS”.

Is DTC “C1604” detected? YES >> Torque sensor is malfunctioning. Replace steering column assembly. Refer to ST-12, "Removal and Installation".

NO >> Check intermittent incident. Refer to GI-41, "Intermittent Incident".

C1601 battery power supply
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1601 BATTERY VOLT When a power supply voltage to the EPS ...

C1606 EPS motor
DTC Logic DTC DETECTION LOGIC DTC Display item Malfunction detected condition Possible cause C1606 EPS MOTOR When the motor driver malfunction of EPS c ...

Other materials:

Rear stabilizer
Exploded View Rear stabilizer bar  Connecting rod (RH)  Rear stabilizer bar bushing  Rear stabilizer bar clamp  Connecting rod (LH)   Front Removal and Installation REMOVAL  Disconnect rear stabilizer links from rear stabilizer bar.   ...

Securing the load
Cargo area luggage hooks There are luggage hooks located in the cargo area as shown. The hooks can be used to secure cargo with ropes or other types of straps. Do not apply a total load of more than 6.5 lbs. (29 N) to a single metal floor hook when securing cargo. WARNING &nb ...

Periodic maintenance
REAR DIFFERENTIAL GEAR OIL Inspection OIL LEAKS Make sure that oil is not leaking from final drive assembly or around it. OIL LEVEL  Remove filler plug (1) and check oil level from filler plug mounting hole as shown. CAUTION: Do not start engine while checking oil level. &nbs ...

© 2014-2025 Copyright www.nirogue.com