Nissan Rogue manuals

Nissan Rogue Service Manual: C1130 engine signal

DTC Logic

DTC DETECTION LOGIC

DTC Display Item Malfunction detected condition Possible causes
C1130 ENGINE SIGNAL 1 When a malfunction is detected in ECM system.
  • ECM
  •  ABS actuator and electric unit (control unit)
  •  CAN communication line

DTC CONFIRMATION PROCEDURE

1.CHECK SELF-DIAGNOSTIC RESULT

With CONSULT.

  1.  Turn ignition switch OFF to ON.
  2.  Perform self-diagnostic result.

Is DTC C1130 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-91, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.CHECK SELF-DIAGNOSTIC RESULT FOR ENGINE SYSTEM

With CONSULT.

Perform self-diagnostic result. Refer to EC-67, "CONSULT Function".

Are any ECM DTCs detected? YES >> Refer to EC-93, "DTC Index".

NO >> GO TO 2.

2.CHECK SELF-DIAGNOSTIC RESULT FOR ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

With CONSULT.

  1.  Perform self-diagnostic result and erase DTCs.
  2.  Turn ignition switch OFF.
  3.  Start engine and drive vehicle for a short period of time.
  4.  Check that malfunction indicator lamp (MIL) turns OFF.
  5.  Stop vehicle and perform self-diagnostic result.

Is DTC C1130 detected? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".

NO >> Check pin terminals and connection of connectors for abnormal conditions. Repair or replace malfunctioning components.

C1121, C1123, C1125, C1127 ABS out valve system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1121 FR LH OUT ABS SOL When a malfunction is detected in front LH ABS OU ...

C1140 actuator relay system
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1140 ACTUATOR RLY When a malfunction is detected in actuator relay. ...

Other materials:

Component parts
Component Parts Location Instrument panel  View with drivers door finisher removed View with center console removed  View with the lower B-pillar trim removed  View with the lower B-pillar trim removed  View with LH rear lower luggage finisher remove ...

Liquid Gasket
REMOVAL OF LIQUID GASKET SEALING After removing the bolts and nuts, separate the mating surface and remove the liquid gasket using Tool (A). Tool Number : KV10111100 (J-37228) CAUTION: Be careful not to damage the mating surfaces.  In areas where the cutter is difficult to use, u ...

Front head restraints
General information The current head restraint position can be stored using the memory function. Safety information Warning Removal or incorrect adjustment of head restraints can cause injuries in the head and neck area. There is a risk of injury. Before driving, install the removed head restrain ...

В© 2014-2023 Copyright www.nirogue.com