Nissan Rogue (T33) 2021-Present Service Manual: B2747-82 Ecu

Nissan Rogue (T33) 2021-Present Service Manual / Driver Information & Multimedia :: Sonar System / Dtc/circuit Diagnosis :: Sonar (sonar Control Unit) / B2747-82 Ecu

DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content) 		DTC detection condition
B2747-82

ECM

(ECMe) 		Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Communication error between sonar control unit and ECM
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Sonar control unit

  • ECM

FAIL-SAFE

—

CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON.

  2. Turn ignition switch OFF and wait for 30 seconds.

  3. Turn ignition switch ON and wait at least 2 seconds or more.

  4. Select “Self Diagnostic Result” mode of “SONAR” using CONSULT.

  5. Check DTC.

Is DTC B2747-82 detected?

YES>>

Proceed to Diagnosis Procedure.

NO-1>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO-2>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

CHECK SELF-DIAGNOSTIC RESULT OF ECM

CONSULT

Check “Self Diagnostic Result” of “ENGINE” using CONSULT.

Is any DTC detected?

YES>>

Perform trouble diagnosis for detected DTC. Refer to DTC Index.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

CONSULT

  1. Turn ignition switch ON.

  2. Erase DTC.

  3. Perform DTC confirmation procedure again. Refer to DTC Description.

Is DTC B2747-82 detected again?

YES>>

Replace sonar control unit. Refer to Removal and Installation.

NO>>

Inspection End.

    B2746-87 4was
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2746-87 4WAS (4WAS) Diagnosis condition When ignition switc...
    B2747-83 Ecu
    DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detection condition B2747-83 ECM (ECMe) Diagnosis condition When ignition switch...

    Other materials:

    Corrosion protection
    Most common factors contributing to vehicle corrosion Moisture-retaining dirt and debris build-up inside body cavities or seams. Paint or coating damage caused by gravel, small stones or minor collisions. Environmental factors influencing corrosion rate Moisture Sand, dirt and water accumulat ...

    P00d2 Ho2s2 Heater
    DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P00D2 00 Heated O2 sensor heater B1 sensor 2 (HO2S heater control circuit range/performance bank 1 sensor 2) Diagnosis condition — Signal (terminal) ...

    Symptom Diagnosis. Squeak and Rattle Trouble Diagnoses
    Work Flow CUSTOMER INTERVIEWInterview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Worksheet during the interview to document the facts and conditions when the noise occurs and any of customer's comments; Refer to Diagnostic Work ...