Nissan Rogue Service Manual: U1010 control unit (CAN)
DTC Logic
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction Detected Condition | Possible cause |
| U1010 | CONTROL UNIT (CAN) | BCM detected internal CAN communication circuit malfunction. | BCM |
Diagnosis Procedure
1.REPLACE BCM
When DTC “U1010” is detected, replace BCM.
>> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS- 135, "Removal and Installation" (without Intelligent Key System).
U1000 CAN COMM CIRCUIT
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellen ...
Low tire pressure warning lamp
Component Function Check
1.CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP
Check that the low tire pressure warning lamp is turned OFF after
illuminating for approximately 1 second,
...
Other materials:
Service data and specifications (SDS)
Wheel Alignment (Unladen*1)
*1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand
tools, and mats are in designated positions.
*2: Since an adjustment mechanism is not included, the value of the left and
right wheels must be used as the standard value.
Wheelarch Height ...
Heater operation
Heating
This mode is used to direct heated air to the foot
outlets. Some air also flows from the defrost
outlets and the side vent outlets.
Press the button to
change to fresh
air intake mode. The indicator
light
will turn off for normal heating.
Press the air flow ...
Cylinder head
Exploded View
Cylinder head
Cylinder head gasket
Refer to INSTALLATION
Removal and Installation
REMOVAL
Remove the timing chain. Refer to EM-45, "Removal and
Installation".
Remove the camshafts. Refer to EM-64, "Exploded View".
& ...
