Nissan Rogue Service Manual: The steering switches are inoperative
Description
One or more of the steering switches to control the information display are inoperative.
Diagnosis Procedure
1.CHECK STEERING SWITCH CIRCUIT
Check steering switch circuit. Refer to MWI-69, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace harness or connector.
2.CHECK STEERING SWITCH RESISTANCE
Check steering switch resistance. Refer to MWI-69, "Component Inspection".
Is the inspection result normal? YES >> GO TO 3.
NO >> Replace steering switch. Refer to AV-65, "Removal and Installation".
3.CHECK SPIRAL CABLE
Check spiral cable for continuity. Refer to MWI-69, "Component Inspection".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Replace spiral cable. Refer to SR-15, "Removal and Installation".
The meter control switch is inoperative
Description
The meter control switches are inoperative when pressed.
Diagnosis Procedure
1.CHECK METER CONTROL SWITCH SIGNAL
Check the meter control switch signal. Refer to MWI-67, "Diagnosis ...
The ambient temperature display is incorrect
Description
The displayed outside air temperature is higher than the actual
temperature.
The displayed outside air temperature is lower than the actual
temperature.
Outside a ...
Other materials:
Wiring diagram
IPDM E/R (INTELLIGENT POWER DISTRIBUTION MODULE ENGINE
ROOM)
Wiring Diagram
...
P0102, P0103 MAF sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0102
MAF SEN/CIRCUIT-B1
(Mass or volume air flow ″A″ circuit low)
An excessively low voltage from the mass air flow sensor is sent to ...
Removal and installation
STARTER MOTOR
Exploded View
REMOVAL
Transaxle assembly
Starter motor
Lower bolt
Upper bolt
Removal and Installation
REMOVAL
Remove battery tray. Refer to PG-77, "Removal and Installation".
Remove terminal B nut and terminal B harness.
R ...
