Nissan Rogue manuals

Nissan Rogue Owners Manual: Seat belt extenders

3rd row shown; 2nd row simi
3rd row shown; 2nd row similar

Seat belt hook

When the seat belt is not in use and when folding down the rear seats, hook the rear seat belts on the seat belt hooks.

If, because of body size or driving position, it is not possible to properly fit the lap/shoulder belt and fasten it, an extender that is compatible with the installed seat belts is available for purchase.

The extender adds approximately 8 in (200 mm) of length and are available for the:

See a NISSAN dealer for assistance with purchasing an extender if an extender is required.

WARNING
  •  Only NISSAN seat belt extenders, made by the same company which made the original equipment seat belts, should be used with NISSAN seat belts.
  •  Adults and children who can use the standard seat belt should not use an extender. Such unnecessary use could result in serious personal injury in the event of an accident.
  •  Never use seat belt extenders to install child restraints. If the child restraint is not secured properly, the child could be seriously injured in a collision or a sudden stop.

Seat belt maintenance

Three-point type seat belt with retractor
WARNING  Every person who drives or rides in this vehicle should use a seat belt at all times.  Do not ride in a moving vehicle when the seatback is reclined. This ...

Child safety
WARNINGDo not allow children to play with the seat belts. Most seating positions are equipped with Automatic Locking Retractor (ALR) mode seat belts. If the seat belt becomes wrappe ...

Other materials:

Repairing material
Foam Repair During factory body assembly, foam insulators are installed in certain body panels and locations around the vehicle. Use the following procedure(s) to replace any factory-installed foam insulators. URETHANE FOAM APPLICATIONS Use commercially available Urethane foam for sealant (f ...

Body construction
Body Construction Outer body side Outer front pillar reinforcement Upper inner front pillar  Rear hoodledge reinforcement Side dash Inner front pillar reinforcement Lower front pillar hinge brace Upper hinge plate Weld nut Upper dash  Upper steering membe ...

CAN system (type 2)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF.  Disconnect the battery cable from the negative terminal.  Check the following terminals and connectors for damage, bend and loose connection (connector side an ...

© 2014-2020 Copyright www.nirogue.com