Nissan Rogue Service Manual: Rear door glass
Exploded View
- Rear door panel
- Rear door glass corner finisher
- Rear door glass rear run channel
- Rear door glass regulator assembly
- Rear door glass power window motor
- Rear door glass
- Rear door glass rubber run channel
Removal and Installation
REMOVAL
- Remove the rear door finisher. Refer to INT-18, "Removal and Installation".
- Remove the rear door vapor barrier (1).
- Temporarily reconnect the rear power window switch.
- Operate the rear power window switch to raise/lower the rear door glass until the rear door glass regulator to rear door glass bolts (A) can be seen and remove.
- Remove screws and rear door corner finisher (1).
- Remove the rear door glass (1).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: • Tighten the rear door regulator bolts to glass specification. Refer to GW-22, "Exploded View"
FITTING INSPECTION
- Check that the rear door glass is securely fit into the rear door glass run channel.
- Lower the rear door glass slightly [approximately 10 to 20 mm (0.39 to 0.79 in)], and check that the clearance to the sash is parallel. If the clearance between the rear door glass and sash is not parallel, loosen the rear door regulator to glass bolts, rear door run channel bolts, and rear door glass bolts to correct the rear door glass position.
Front power window motor
Removal and Installation
REMOVAL
Remove front door glass regulator. Refer to GW-16, "Removal and
Installation".
Remove screws (A) and front power window motor (1) from ...
Rear regulator
Exploded View
Rear door panel
Rear door glass corner finisher
Rear door glass rear run channel
Rear door regulator assembly
Rear door glass power window motor
Rear door glass
& ...
Other materials:
DTC/circuit diagnosis
P1610 LOCK MODE
Description
ECM forcibly switches to the mode that inhibits engine start, when engine
start operation is performed 5 times
or more while communication between ECM and BCM is not normal.
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC B1610 is displayed with DTC U1000, fi ...
Vehicle information display warnings and indicators
Engine start operation
No Key Detected (if so equipped)
Shift to Park
Key battery low (if so equipped)
Engine start operation for Intelligent Key system
(if I-Key battery level is low) (if so
equipped)
Key ID Incorrect (if so equipped)
Relea ...
Off-road recovery
If the right side or left side wheels unintentionally
leave the road surface, maintain control of the
vehicle by following the procedure below. Please
note that this procedure is only a general guide.
The vehicle must be driven as appropriate based
on the conditions of the vehicle, road and t ...
