Nissan Rogue Service Manual: Preparation
Special Service Tools
The actual shape of the tools may differ from those illustrated here.
|
Tool number (TechMate No.) Tool name |
Description | |
| — (J-44372) Pull gauge |
|
Measuring steering wheel turning force, rack sliding force and ball joint swinging force |
| KV40107300 ( — ) Boot Band crimping tool |
|
Installing boot bands (large diameter) |
Commercial Service Tools
|
Tool name |
Description |
|
| Steering wheel puller |
|
Removing steering wheel |
| Ball joint remover |
|
Removing ball joint |
| ST3127S000
(J-25765-A)
Preload gauge 1. GG9103000 (J-25765-A) Torque wrench 2. HT62940000 ( – ) Socket adapter 3. HT62900000 ( – ) Socket adapter |
|
Inspecting of rotating torque for ball joint and steering column |
| Power tool |
|
Loosening nuts, screws and bolts |
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. If necessary, repair or
replace these parts.
×: Applicabl ...
Other materials:
P0181 FTT sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0181
FTT SENSOR
(Fuel temperature sensor ″A″ circuit range/
performance)
A
Rationally incorrect voltage from the sensor is sent ...
Engine oil
Inspection
ENGINE OIL LEVEL
NOTE:
Before starting engine, put vehicle horizontally and check the engine oil level.
If engine is already started, stop
it and allow 5 minutes before checking.
Pull out oil level gauge and wipe it clean.
Insert oil level gauge and check the engin ...
Basic inspection
INSPECTION AND ADJUSTMENT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM)
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description
BEFORE REPLACEMENT
When replacing BCM, save or print current vehicle specification with CONSULT
configuration before replacement.
NOTE:
If “Befo ...
