Nissan Rogue manuals

Nissan Rogue Service Manual: Preparation

Special Service Tool

The actual shape of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name Description
KV40107300 ( — ) Boot band crimping tool

Installing boot band
KV40107500 ( — ) Drive shaft attachment

Removing drive shaft
KV38107900 ( — ) Protector

Installing drive shaft
a: 32 mm (1.26 in) dia.

Commercial Service Tools

Tool name Description
Ball joint remover

Removing wheel stud
Drive shaft puller

Removing drive shaft joint sub assembly
Sliding hammer

Removing drive shaft
Power tool

Loosening nuts, screws and bolts
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting Chart Use chart below to find the cause of the symptom. If necessary, repair or replace these parts. ×: Applicable ...

Other materials:

B1428 seat belt buckle switch IH
Description DTC B1428 SEAT BELT BUCKLE SWITCH LH The air bag diagnosis sensor unit monitors the seat belt buckle switch LH status. If the control unit detects an open or short condition in the circuit, it will set the DTC. PART LOCATION Refer to SRC-6, "Component Parts Location". D ...

C1142 press sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1142 PRESS SEN CIRCUIT When a malfunction is detected in master cylinder pressure sensor Stop lamp switch system  ABS actuator and electric unit ...

Push-button ignition switch positions
LOCK (Normal parking position): The ignition switch can only be locked in this position. The ignition switch will lock when any door is opened or closed with the ignition switched off. ON (Normal operating position): This position turns on the ignition system and electrical accessories. ...

© 2014-2025 Copyright www.nirogue.com