Nissan Rogue manuals

Nissan Rogue Service Manual: Preparation

Special Service Tool

The actual shape of the tools may differ from those illustrated here.

Tool number (TechMate No.) Tool name

Description

— (J-39570) Chassis Ear

Locating the noise
— (J-50397) NISSAN Squeak and Rattle Kit

Repairing the cause of noise
— (J-46534) Trim Tool Set

Removing trim components

Commercial Service Tool

(TechMate No.) Tool name

Description

(J-39565) Engine Ear

Locating the noise
( — ) Suction lifter

Holding the door glass
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...

Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs. Use the Diagnostic Workshee ...

Other materials:

Periodic maintenance
IN-CABIN MICROFILTER Removal and Installation REMOVAL  Release the tab and remove the in-cabin microfilter cover (1) from under the RH side of the instrument panel. CAUTION: Use care when lifting up on the tab to avoid damaging it.  Remove the in-cabin microfilter (2). CAUT ...

Main power supply and ground circuit
Diagnosis Procedure 1.CHECK TCM POWER CIRCUIT (PART 1)  Turn ignition switch OFF.  Disconnect TCM connector.  Check voltage between TCM harness connector terminals and ground. Is the inspection result normal? YES >> GO TO 2. NO >> GO TO 4. 2.CHECK TCM ...

Calibration of decel G sensor
Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed. NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration. Work Procedure Decel G sensor calibration CAUTION: ...

© 2014-2019 Copyright www.nirogue.com