Nissan Rogue Owners Manual: Manual operation
Fan speed control
Press the fan control buttons 
to manually
control the fan speed.
Press the AUTO button to return to automatic control of the fan speed.
Air recirculation
Press the 
air recirculation
button to recirculate
interior air inside the vehicle. The
indicator light on the button will come on.
The air recirculation cannot be activated when
the air conditioner is in the 
front defrosting
mode.
Fresh air intake
Press the
fresh air intake
button to draw
outside air into the passenger compartment.
The
indicator light on the
button will come
on.
Air flow control
Pressing the MODE button manually controls air flow and selects the air outlet:
— Air flows mainly from center
and
side vents.
— Air flows mainly from center and
side vents and foot outlets.
— Air flows mainly from foot
outlets
and partly from defroster.
— Air flows mainly from defroster
and
foot outlets.
To turn system off
Press the OFF button.
Rear window and outside mirror (if so equipped) defroster button
For additional information, refer to “Rear window and outside mirror (if so equipped) defroster switch” in the “Instruments and controls” section of this manual.
Automatic operation
Cooling and/or dehumidified heating
(AUTO)
This mode may be used all year round as the
system automatically works to keep a constant
temperature. Air flow distribution and fan speed
are also cont ...
Operating tips
When the engine coolant temperature and
outside air temperature are low, the air flow
from the foot outlets may not operate for a
maximum of 150 seconds. However, this is
not a malfunction. ...
Other materials:
How to erase permanent DTC
Description
OUTLINE
When a DTC is stored in ECM
When a DTC is stored in ECM and MIL is ON, a permanent DTC is erased with MIL
shutoff if the same malfunction
is not detected after performing the driving pattern for MIL shutoff three times
in a raw.
*1: When the same malfunction is detecte ...
ECU diagnosis information
BCM
Reference Value
NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read T ...
P0078 EVT control solenoid valve
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condit
P0078
EX V/T ACT/CIRC-B1
(Exhaust valve control solenoid circuit bank
1)
An improper voltage is sent to the ECM through exhaust valve timing
co ...
