Nissan Rogue Owners Manual: Loading tips

Nissan Rogue Owners Manual / Technical and consumer information / Vehicle loading information / Loading tips

The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./C.M.V.S.S. certification label.
Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR.

WARNING

Properly secure all cargo with ropes or straps to help prevent it from sliding or shifting. Do not place cargo higher than the seatbacks.
In a sudden stop or collision, unsecured cargo could cause personal injury.
Do not load your vehicle any heavier than the GVWR or the maximum front and rear GAWRs.
If you do, parts of your vehicle can break, tire damage could occur, or it can change the way your vehicle handles. This could result in loss of control and cause personal injury.
Overloading not only can shorten the life of your vehicle and the tire, but can also cause unsafe vehicle handling and longer braking distances. This may cause a premature tire failure which could result in a serious accident and personal injury. Failures caused by overloading are not covered by the vehicle’s warranty.

Measurement of weights

Secure loose items to prevent weight shifts that could affect the balance of your vehicle. When the vehicle is loaded, drive to a scale and weigh the front and the rear wheels separately to determine axle loads. Individual axle loads should not exceed either of the GAWR. The total of the axle loads should not exceed the GVWR.

These ratings are given on the vehicle certification label. If weight ratings are exceeded, move or remove items to bring all weights below the ratings.

Securing the load

Cargo area luggage hooks There are luggage hooks located in the cargo area as shown. The hooks can be used to secure cargo with ropes or other types of straps. Do not apply a total load of m ...

Towing a trailer

WARNINGOverloading or improper loading of a trailer and its cargo can adversely affect vehicle handling, braking and performance and may lead to accidents. CAUTION ...

Other materials:

Power seat switch
Exploded View Seat cushion outer finisher Power seat switch Removal and Installation REMOVAL NOTE: LH shown, RH similar. Using a suitable tool release clips and remove seat cushion outer finisher (1). : Clip Disconnect harness connector from power seat switch. ...

ECU diagnosis information
BCM Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read T ...

Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (J-46532) Brake height tool Measuring brake pedal height 38-PFM92 ( — ) ProCut™ PFM Serie ...