Nissan Rogue manuals

Nissan Rogue Owners Manual: Emission control system warranty

Your NISSAN vehicle is covered by the following emission warranties:

For USA

  1.  Emission Defects Warranty
  2.  Emissions Performance Warranty

Details of this warranty may be found with other vehicle warranties in your Warranty Information Booklet which comes with your NISSAN vehicle.

If you did not receive a Warranty Information Booklet, or it is lost, you may obtain a replacement by writing to:

For Canada

Emission Control System Warranty

Details of this warranty may be found with other vehicle warranties in your Warranty Information Booklet which comes with your NISSAN vehicle.

If you did not receive a Warranty Information Booklet, or it is lost, you may obtain a replacement by writing to:

Uniform tire quality grading
DOT (Department of Transportation) Quality Grades: All passenger car tires must conform to federal safety requirements in addition to these grades. Quality grades can be found where applicable o ...

Reporting safety defects
For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (N ...

Other materials:

Basic inspection
SERVICE INFORMATION FOR ELECTRICAL INCIDENT Work flow STEP DESCRIPTION STEP 1 Get detailed information about the conditions and the environment when the incident occurred. The following are key pieces of information required to make a good analysis: WH ...

Diagnosis system (combination meter)
Description COMBINATION METER SELF-DIAGNOSIS MODE The following meter functions can be checked during Combination Meter Self-Diagnosis Mode:  Pointer sweep of speedometer, tachometer and gauges.  Illumination of all LCD segments and color patterns for meter displays.  I ...

P052A, P052B intake valve timing control
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P052A CAMSHAFT POSITION TIMING B1 (Cold start “A” camshaft position timing over-advanced bank 1) There is a gap between angle of target and ...

© 2014-2020 Copyright www.nirogue.com