Nissan Rogue manuals

Nissan Rogue Service Manual: ECU diagnosis information

BCM, IPDM E/R

List of ECU Reference

List of ECU Reference

System description
COMPONENT PARTS Component Parts Location Right rear wheel area Instrument panel Engine compartment Left side of instrument panel (view with trim panel removed) No. ...

Wiring diagram
HEADLAMP Wiring Diagram DAYTIME LIGHT SYSTEM Wiring Diagram AUTO LIGHT SYSTEM Wiring Diagram FRONT FOG LAMP SYST ...

Other materials:

P050A, P050B, P050E cold start control
Description ECM controls ignition timing and engine idle speed when engine is started with pre-warming up condition. This control promotes the activation of three way catalyst by heating the catalyst and reduces emissions. DTC Description DTC DETECTION LOGIC DTC No. CONSULT scre ...

C1160 DECEL G SEN SET
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1160 DECEL G SEN SET When calibration of yaw rate/side/decel G sensor is not complete. Yaw rate/side/decel G sensor  Harness or connector   ...

Performance test
Inspection INSPECTION PROCEDURE  Connect recovery/recycling/recharging equipment (for HFC-134a) or manifold gauge.  Start the engine, and set to the following condition. Test condition Maintain test condition until A/C system becomes stable. (Approximately 10 minute ...

В© 2014-2020 Copyright www.nirogue.com