Nissan Rogue Service Manual: Wiper and washer switch
Removal and Installation
The wiper and washer switch is serviced as a part of the combination switch. Refer to BCS-76, "Removal and Installation".
Front wiper motor
Removal and Installation
REMOVAL
Remove the front drive assembly. Refer to WW-66, "Removal and
Installation".
Remove the bolts (A) from the front wiper drive assembly ( ...
Rear wiper arm
Exploded View
Rear wiper motor
Rear wiper arm
Rear wiper blade
Rear wiper arm cover
Seal
Removal and Installation
REMOVAL
Check that the rear wiper is in the aut ...
Other materials:
P0962 pressure control solenoid A
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0962
PC SOLENOID A
(Pressure Control Solenoid A Control Circuit
Low)
When all of the following conditions are satisfied and this state is
maint ...
Battery
How to Handle Battery
CAUTION:
If it becomes necessary to start the engine with a booster
battery and jumper cables, use a 12-volt
booster battery.
After connecting battery cables, ensure that they are tightly
clamped to battery terminals for good
contact.
Never ...
Sunshade system does not operate properly
Diagnosis Procedure
1.CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit.
Refer to BCS-68, "Diagnosis Procedure" (with Intelligent Key System), BCS-128,
"Diagnosis Procedure" (without
Intelligent Key System).
Is the inspection result no ...
