Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-22, "Wiring Diagram".
1. CHECK FRONT AND REAR WASHER MOTOR FUSE
Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 2.
2. CHECK FRONT AND REAR WASHER MOTOR POWER SUPPLY
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the harness or connectors.
3. CHECK FRONT AND REAR WASHER MOTOR CIRCUIT CONTINUITY
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace the harness or connectors.
4. CHECK WIPER AND WASHER SWITCH GROUND CIRCUIT
Check continuity between combination switch (wiper and washer switch) harness connector and ground.
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace the harness or connectors.
5. CHECK WIPER AND WASHER SWITCH
Check wiper and washer switch. Refer to WW-45, "Component Inspection".
Is the inspection result normal? YES >> Replace front and rear washer motor. Refer to WW-57, "Removal and Installation".
NO >> Replace wiper and washer switch. Refer to BCS-76, "Removal and Installation".
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
How to follow trouble diagnoses
Description
NOTICE:
Trouble diagnoses indicate work procedures required to diagnose problems
effectively. Observe the following
instructions before diagnosing.
Before performing trouble diagnoses, read the “Work Flow” in each
section.
After repairs, re-check that the pr ...
Rapid air pressure loss
Rapid air pressure loss or a “blow-out” can occur
if the tire is punctured or is damaged due to
hitting a curb or pothole. Rapid air pressure loss
can also be caused by driving on under-inflated
tires.
Rapid air pressure loss can affect the handling
and stability of the vehicle, especial ...