Nissan Rogue manuals

Nissan Rogue Service Manual: Unbalance steering wheel turning force and return between right and left

Nissan Rogue Service Manual / Steering / Steering Control System / Symptom diagnosis / Unbalance steering wheel turning force and return between right and left

Description

Unbalance steering wheel turning force and return between right and left.

Diagnosis Procedure

1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP

Check the EPS warning lamp while engine is running.

Does the EPS warning lamp turn OFF? YES >> GO TO 2.

NO >> Refer to STC-30, "Diagnosis Procedure".

2.CHECK WHEEL ALIGNMENT

  1.  Check the wheel alignment. Refer to FSU-8, "Adjustment".
  2.  Perform “EPS” self-diagnosis.

Is the inspection result normal? YES >> GO TO 3.

NO >> Adjustment of wheel alignment. Refer to FSU-8, "Adjustment".

3.CHECK EPS CONTROL UNIT SIGNAL

With CONSULT

  1.  Start the engine.

    CAUTION: Never drive the vehicle.

  2.  Turn steering wheel from full left stop to full right stop.
  3. Select “DATA MONITOR” of “EPS” and select “TORQUE SENSOR”.
  4.  Perform the torque sensor inspection.

Check EPS control unit signal

Is the inspection result normal? YES >> GO TO 5.

NO >> GO TO 4.

4.CHECK EPS MOTOR

Perform the trouble diagnosis of EPS motor. Refer to STC-24, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 5.

NO >> Repair or replace the specific malfunctioning part.

5.CHECK STEERING WHEEL TURNING FORCE

Check the steering wheel turning force. Refer to ST-7, "Inspection".

Is the inspection result normal? YES >> Inspection End.

NO >> Check the steering wheel turning force for mechanical malfunction. Refer to ST-7, "Inspection".

Steering wheel turning force is heavy or light
Description Steering wheel turning force is heavy or light. Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT  Turn the ignition switch OFF to ON.  Perform “EPS” self-d ...

Unbalance steering wheel turning force (torque variation)
Description Unbalance steering wheel turning force (torque variation). Diagnosis Procedure 1.PERFORM SELF-DIAGNOSIS With CONSULT  Turn the ignition switch OFF to ON.  Perform “EP ...

Other materials:

C1155 brake fluid level switch
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1155 BR FLUID LEVEL LOW When brake fluid level low signal is detected Harness or connector  ABS actuator and electric unit (control unit)   ...

RearView Monitor (if so equipped)
When the shift lever is shifted into the R (Reverse) position, the monitor display shows the view to the rear of the vehicle. WARNINGFailure to follow the warnings and instructions for proper use of the RearView Monitor could result in serious injury or death.  The Re ...

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC CONSULT Display DTC Detection Condition Possible Cause CAN COMM CIRCUIT [U1000] When IPDM E/R cannot communicate with CAN communication sig ...

© 2014-2022 Copyright www.nirogue.com