Nissan Rogue manuals

Nissan Rogue Service Manual: U1010 control unit (CAN)

Description

Initial diagnosis of combination meter.

DTC Logic

DTC DETECTION LOGIC

DTC

CONSULT

Detection Condition

Possible Cause

U1010 CONTROL UNIT (CAN) [U1010] When detecting error during the initial diagnosis of the CAN controller of combination meter. Combination meter

Diagnosis Procedure

1.REPLACE COMBINATION METER

When DTC "U1010" is detected, replace combination meter.

>> Replace combination meter. Refer to MWI-82, "Removal and Installation".

U1000 CAN COMM circuit
DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Condition Possible Cause U1000 CAN COMM CIRC [U1000] When combination meter is not transmitting ...

B2205 vehicle speed
Description Vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) via CAN communication line to combination meter. DTC Logic DTC DETECTION LOGIC DTC ...

Other materials:

Emission control system warranty
Your NISSAN vehicle is covered by the following emission warranties: For USA  Emission Defects Warranty  Emissions Performance Warranty Details of this warranty may be found with other vehicle warranties in your Warranty Information Booklet which comes with your NISSAN vehicle ...

Intersection collision warning
Principle The system may prevent some accidents with cross traffic at intersections and junctions. In the event of an accident, the system may reduce impact speed. The system sounds a warning in the city speed range before an imminent collision and activates brakes independently, if needed. General ...

General information
Depending on the situation, the vehicle is in one of the three states: Idle state. Standby state. Drive-ready state. Idle state Principle When the vehicle is in idle state, it is switched off. General information The vehicle is in idle state prior to opening from the outside and after exiting a ...

В© 2014-2022 Copyright www.nirogue.com